JVC KD-LX555R - Manual (Page 10)

10
ENGLISH
LVT1008-001A [E/EX]
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM
band (FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you
want to store FM stations into.
1 Press SOURCE ATT to
select FM as the source.
2 If necessary, press and
hold BAND MODE (M) to
select the FM band
number (FM1, FM2 or
FM3).
Each time you press and hold the button,
the FM band changes as follows:
2
Press and hold both buttons for
more than 2 seconds.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons
— No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
2
Press and hold ¢ or 4
until “M (manual)” starts flashing on
the display.
3
Tune in to a station you want while
“M” is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (50 kHz intervals for FM
and 9 kHz intervals for AM–MW/LW) until
you release the button.
When an FM stereo broadcast is hard to
receive:
1 Press BAND MODE (M) while listening to an
FM stereo broadcast (the ST indicator lights up
while receiving an FM stereo broadcast).
“MODE” appears on the display.
2 Press MONO, while “MODE” is still on the
display, so that the MO indicator lights up on
the display.
The sound you hear becomes monaural but
the reception will be improved (the ST indicator
goes off).
Each time you press the button, the MO
indicator lights up and goes off alternately.
Press ¢ to tune in to
stations of higher frequencies.
Press 4 to tune in to
stations of lower frequencies.
“SSM” appears, then disappears when automatic
preset is over.
SOURCE
ATT
M
BAND
MODE
FM1 FM2 FM3
DISP
BAND
MODE
SSM
D M
EN09-11KD-LX555R[E]f.p65 02.12.11, 16:28 10