JVC XV-D701BK - Manual (Page 23)

19
Getting started
Getting started
XV-D701BK [C] EN
LET0141-002A
English
Français
To connect to an amplifier/receiver equipped with Dolby Digital 5.1-channel inputs
The Dolby Digital decoder is built in the unit, so you can enjoy the Dolby digital surround sound without the need of
an external decoder.
Connect the unit’s 5.1-channel outputs to the Dolby Digital 5.1-channel inputs of an amplifier or receiver using the
supplied audio cables.
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on
units.
• An Audio/video cable is recommended for connection to the FRONT terminal (Yellow jack (for Video Signal) is not
used in this connection).
NOTE
¶
When using the 5.1-channel outputs of the unit, set the "DOWN MIX" in the "PREFERENCE 2" on-screen display
to "OFF" and select "5.1 CHANNEL" or "EXPERT" in the "SPK.SETTING" on-screen display. If the "EXPERT" is
selected, you can control the audio output balance of the speakers (see pages 57 and 60).
LEFT
FRONT REAR CENTER
SUBWOOFER
PCM/STREAM
COAXIAL OPTICAL
VIDEO S-VIDEO Y
RIGHT
AV COMPU LINK
VIDEO OUT
ANALOG
AUDIO OUT
DIGITAL
P B
COMPONENT
P R
AUDIO IN
REAR
RIGHT
RIGHT
FRONT
LEFT
LEFT
CENTER
SUBWOOFER
Audio cable (supplied)
The unit
Amplifier or receiver
White Red
White
Red
White Red
White Red
Audio cable (supplied)
Audio/video cable (supplied)
White
Red
White
Red
Y
ellow
Yellow