JVC XV-D701BK - Manual (Page 24)

20
Getting started
XV-D701BK [C] EN
LET0141-002A
LEFT
FRONT REAR CENTER
SUBWOOFER
PCM/STREAM
COAXIAL OPTICAL
VIDEO S-VIDEO Y
RIGHT
AV COMPU LINK
VIDEO OUT
ANALOG
AUDIO OUT
DIGITAL
P B
COMPONENT
P R
IN
DIGITAL
IN
AUDIO
LEFT
COAXIAL
OPTICAL
RIGHT
To connect to audio equipment with a digital input
Connection to an amplifier/receiver with digital input, Dolby Digital decoder/amplifier with
built-in Dolby Digital decoder, or an amplifier with built-in DTS and Dolby Digital decoder
You can enhance the sound quality by connecting the unit’s DIGITAL OUT (coaxial or optical) with the digital input of
an amplifier, DAT or MD by using a digital cable. The digital stereo audio signal from a disc is directly transferred.
And, if you connect with a Dolby Digital decoder or an amplifier with built-in Dolby Digital decoder by using a coaxial
or optional digital cable, you can enjoy high-quality audio and surround sound. The unit also is compatible with the
DTS function. When you make a digital connection, leave the 2 channel analog audio connection as it is. Otherwise,
depending on the disc type, no audio may be reproduced.
¶
DTS (Digital Theater System)
DTS is a newly-developed surround system which can handle more amount of data than Dolby Digital, providing
better audio quality.
Though the number of audio channels is 5.1 which is same as Dolby Digital, DTS provides fat sound and better
signal-to-noise ratio, thanks to the lower audio compression ratio format. It also provides wide dynamic range
and better separation, resulting magnificent sound.
¶
When you connect the audio equipment with a digital input, before using, change the “DIGITAL AUDIO OUTPUT”
setting in the “PREFERENCE 2” on-screen display according to the connected audio equipment with a digital
input. When the “DIGITAL AUDIO OUTPUT” setting is not set correctly, loud noise may be played back from
speakers, and it cause of the breakdown of your speakers. See “DIGITAL AUDIO OUTPUT” on page 56.
¶
With this connection, the unit’s settings for "COMPRESSION" and "DOWN MIX" in the "PREFERENCE 2" on-
screen display and the "SPK.SETTING" on screen display are invalid. Settings for these items must be made
from the decoder.
• For digital connection, connect the unit’s DIGITAL out (coaxial or optical) to the digital input of a Dolby Digital
decoder or an amplifier with built-in Dolby Digital decoder using an optional digital cable.
Audio cable
(supplied)
The unit
Amplifier/receiver with digital input,
Dolby Digital decoder/amplifier with
built-in Dolby Digital decoder, or an
amplifier with built-in DTS and Dolby
Digital decoder
Optical digital cable
(not supplied)
White Red
White
Red
NOTES
Coaxial digital cable
(not supplied)