JVC XV-D701BK - Manual (Page 28)

24
Getting started
XV-D701BK [C] EN
LET0141-002A
To use the remote control unit for TV operation
You can operate a JVC TV with the remote control unit. To operate another
manufacture’s TV, you have to change the remote control signal. Also refer to the
manual supplied with your TV.
Changing the remote control signal
1 Set CATV TV DVD on the remote control unit to TV.
2 Press and hold
TV
POWER
, then press
SET
.
Do not release TV
POWER . Keep holding
TV
POWER until the next step is completed.
3 Holding
TV
POWER , enter the manufacturer’s code (two digits) using 0 to 9 .
See the lists on the right to find the manufacturer’s code.
4 Release
TV
POWER .
The following buttons can be used for operating the TV:
5 Try to operate your TV by pressing
TV
POWER .
If your TV turns on or off, you have entered the correct code.
Using the remote control unit
You can operate the unit with the remote control unit, and you can also operate
your TV or other components with the remote control unit.
NOTE
¶
If there is more than one code listed for your brand of TV, try each one until
the correct one is entered.
No. Manufacturer
01 JVC
02 MAGNAVOX
03 MITSUBISHI
04 PANASONIC
05 RCA
06 SHARP
07 SONY
08 TOSHIBA
09 ZENITH
10 HITACHI
11 PANASONIC
12 SAMSUNG
13 SANYO
14 SANYO
15 SAMSUNG
Manufacturer code list
TV
POWER
CH
+
–
TV
VOLUME
+
–
0 to 9
and +10
CANCEL
TV/VIDEO
10
CH RETURN
Turns the TV on or off.
Changes the TV channels.
(with CATV
TV
DVD set to TV only)
Adjusts the TV volume.
Selects the TV channels. +10 will function as the ENTER button if
your TV requires pressing the ENTER button after selecting a
channel number.
(with CATV TV DVD set to TV only)
You can switch input mode (either TV or VIDEO).
(with CATV
TV
DVD set to TV only)
Returns to the previous channel. (only valid for JVC TVs)