JVC CA-MXK50R - Manual (Page 11)

– 8 –
To audio output
Audio/video
equipment
CANCEL
/ DEMO
CANCEL
/ DEMO
Canceling the Display Demonstration
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration, press
CANCEL/DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) and
continue until you cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more
than 2 seconds.
Connecting Other Equipment
You can connect both analog and digital equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX IN jacks by using audio cords (not
supplied).
NOW, you can plug in the unit and other
connected equipment FINALLY!
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
DIGITAL OUT [OPTICAL] terminal.
DIGITAL OUT
(OPTICAL)
To optical
digital input
Before connecting the other
equipment, remove the protective
plug from the terminal.
Audio equipment
with an optical digital
input
Protective
plug
AUX IN
01-10.MX-K50R[B].pm6 02.4.12, 4:41 PM 8