JVC UX-F70MD - Manual (Page 50)

– 45 –
English
FORM GR? ENTRY GR?
DIVIDE GR?
UNGROUP? UNGR ALL?
ERASE GR?
Canceled
JOIN GR?
MOVE GR?
GR 1 TITLE?
2
Press MD TITLE INPUT/EDIT repeatedly while
pressing MD GROUP to select “DIVIDE GR?”
The source changes to “MD.”
• Each time you press MD TITLE INPUT/EDIT while
pressing MD GROUP, the group editing mode
changes as follows:
• If you want to stop this editing process, press CANCEL.
3
Press SET.
4
Press
¢ or 4 to select the track as the dividing
point.
• You can select the track using number buttons. In this
case, the selected track starts playback repeatedly.
• The track selected in this step will be the first track in
the divided group.
• You cannot select the first track in a group as the
dividing point.
• During playback:
The selected track starts playback repeatedly.
5
Press SET.
“<DIVIDE GR>” appears on the display.
• To cancel the setting, press CANCEL, then repeat step 4.
6
Press ENTER to finish the editing procedure.
“EDITING” then “UTOCwriting” appears on the
display while the editing you have made is being
recorded on the MD.
To join the divided groups, see the JOIN GR function to
the right.
FORM GR? ENTRY GR?
DIVIDE GR?
UNGROUP? UNGR ALL?
ERASE GR?
Canceled
JOIN GR?
MOVE GR?
GR 1 TITLE?
Joining Two Groups — JOIN GR
This function allows you to join two adjacent groups into a
single group.
When the groups have each title, the title of the preceding
group is reassigned to the joined group.
Once two groups are joined, the other groups are renumbered.
• To stop any time during editing process, press
MD TITLE INPUT/EDIT.
On the remote control ONLY:
1
Insert an MD to edit.
2
Press MD TITLE INPUT/EDIT repeatedly while
pressing MD GROUP to select “JOIN GR?”
The source changes to “MD.”
• Each time you press MD TITLE INPUT/EDIT while
pressing MD GROUP, the group editing mode
changes as follows:
• If you want to stop this editing process, press CANCEL.
3
Press SET.
4
Press
¢ or 4 to select the two adjacent groups
to be joined.
• During playback:
The tracks in the selected group are played back repeatedly.
5
Press SET.
“<JOIN GR>” appears on the display.
• You cannot join two groups if ungrouped track is in
between the two groups. “CANNOT JOIN” appears
on the display.
• To cancel the setting, press CANCEL, then repeat step 4.
6
Press ENTER to finish the editing procedure.
“EDITING” then “UTOCwriting” appears on the
display while the editing you have made is being
recorded on the MD.
To divide the joined group, see the DIVIDE GR function
on page 44.
EN40-47UX-F70MD[UB]_f 01.7.10, 5:20 PM 45