JVC HR-XV48E - Manual (Page 11)

Masterpage:Right-No-Heading
EN
11
Filename [XV48EX_EN_06Index.fm]
Page 11 October 9, 2004 10:33 pm
D
Perform Auto Set Up.
Press ENTER. The AUTO SET/T-V LINK display appears
on the TV screen.
● When you have connected the unit to a TV offering T-V Link
via a fully-wired 21-pin SCART cable (
੬
pg. 9) and the TV is
turned on, the unit automatically performs the Preset
Download (
੬
pg. 12) even if you select “AUTO SET” for Auto
Set Up function.
E
Confirm/Set video channel.
With RF Connection
The video channel that is
blinking on the front display
panel is your video channel. Press ENTER.
● If you have selected
MAGYARORSZÁG, CESKÁ
REPUBLIKA, POLSKA or
OTHER EASTERN EUROPE in step
B on page 10, “2” appears
instead of “1.”
● To view picture signals from the unit, set your TV to the video
channel.
With AV Connection
Press PR – until the front
display panel shows “1 – –”
(or “2 – –”). Now the video channel is set to off. Then
press ENTER.
● To view picture signals from the unit, set your TV to its AV
mode.
NOTES:
● In areas where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto
Clock Set nor Auto Guide Program Number Set.
● If there is a power cut, or if you press 1 or SET UP while Auto
Set Up is in progress, Auto Set Up will be interrupted; be sure
to turn off the unit power once and try again from step
A.
● Auto Clock Set may not function properly depending on the
reception condition.
● If no sound accompanies the picture or the audio sounds
unnatural on some channels that have been stored by Auto Set
Up, the TV system setting for those channels may be incorrect.
Select the appropriate TV system for those channels.
(
੬
pg. 61, “INFORMATION”)
Press rt to move the
highlight bar (pointer) to
“AUTO SET” and press
ENTER or e.
● When selecting “AUTO SET,”
“Auto” also appears on the
front display panel.
While Auto Set Up is in progress, do NOT press any
button on the unit or remote control until the front
display panel shows either the display as illustrated in
step
E or “– –:– –” as illustrated on page 13.
● The AUTO SET screen will
appear on the TV screen. As
Auto Set Up progresses, the
“q” mark on the TV screen
moves from left to right.
Beginning End
ATTENTION
Once you have performed Auto Set Up, even if the unit’s
memory backup has expired, all the stored stations and their
Guide Program numbers remain in the unit’s memory and
the unit will not perform Auto Set Up again. The unit
performs only Auto Clock Set when the unit is turned on.
If you have moved to a different area, perform each setting as
required.
● Video channel setting (for RF connection users) ੬
pg. 64
● Tuner setting ੬
pg. 59
● Clock setting ੬
pg. 65
If a new station starts broadcasting in your area, perform
tuner setting (
੬
pg. 59) and, if necessary, video channel
setting (
੬
pg. 64).
After “Auto Set Up” is completed, perform “Monitor
Set (DVD deck)” on page 14.
XV48EX_EN_01.book Page 11 Saturday, October 9, 2004 10:34 PM