JVC HR-XV48E - Manual (Page 20)

Filename [XV48EX_EN_07S-VHS.fm]
Masterpage:Left+
20
EN
Page 20 October 9, 2004 10:34 pm
OPERATIONS ON VHS DECK (cont.)
Instant ReView
Simply by pressing a single button, the unit power comes on,
rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the unit is off and that the Timer
mode is disengaged.
Activate Instant ReView.
Press . The unit power comes on and the unit
searches for the index code indicating the start of the last
timer-recorded programme. Once it’s found, playback
begins automatically.
● To watch the first of the 3 programmes, press three
times. The unit searches and begins playback automatically.
You can access a programme as far as 9 index codes away
from the current tape position.
Repeat Playback
Your unit can automatically play back the whole tape 100 times
repeatedly.
1 Start playback.
Press 4.
2 Activate Repeat Playback.
Press 4 and hold for over 5 seconds, then release.
● The Play indicator ($) on the front display panel blinks slowly.
● After playing back a tape 100 times, the unit stops
automatically.
3 Stop Repeat Playback.
Press 8 at any time.
● Pressing 4, 3, 5 or 9 also stops Repeat Playback.
Manual Tracking
Your unit is equipped with automatic tracking
control. During playback, you can override this
and adjust the tracking manually by pressing the
TRACKING +/– buttons.
1 Override automatic tracking.
During playback, press TRACKING + and –
at the same time.
2 Adjust the tracking manually.
Press TRACKING +/–.
● Press TRACKING + and – at the same time again to return to
automatic tracking.
NOTE:
When a new tape is inserted, the unit enters the automatic
tracking mode automatically.
Soundtrack Selection
Your unit is capable of recording three soundtracks (HI-FI L,
HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing A.MONITOR changes the soundtrack as follows:
NOTES:
● “HIFI L j h R” should normally be selected. In this mode,
Hi-Fi stereo tapes are played back in stereo, and the normal
audio track is played back automatically for tapes with only
normal audio.
● For instructions on recording stereo and bilingual
programmes, refer to page 23.
● “O.S.D.” must be set to “ON” or the on-screen displays will
not appear. (
੬
pg. 53)
Slide to the
right.
Track
Use
On-screen display
HI FI
L j h R
For Hi-Fi stereo tapes
HI FI
L j
For main audio of Bilingual tapes
HI FI
h R
For sub audio of Bilingual tapes
NORM For audio-dubbed tapes
HI FI
NORM
For audio-dubbed tapes
XV48EX_EN_01.book Page 20 Saturday, October 9, 2004 10:34 PM