Jensen JIPS-290I - Manual (Page 13)

13
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
3. For better Clock Display clarity, avoid operating the unit under direct sunlight or in strong room
illumination.
4. Unplug the unit from the electrical power outlet immediately in case of malfunction.
CLEANING THE UNIT
 To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
 The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts.
 If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinet.
 If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or
polishes as these will damage the finish of your unit.
CAUTION :
Never allow any water or other liquids to get inside the unit while cleaning.
TROUBLESHOOTING GUIDE
Symptom Possible Problem Solution
AC Adaptor is not plugged
into a wall outlet or the
connector is not plugged
into the power supply jack
on the back of the unit.
Plug the AC adaptor into a wall outlet and plug
the connector into the supply jack on the unit.
The unit does not
respond (no power).
Wall outlet is not
functioning. Plug another device into the same outlet to
confirm the outlet is working.
iPad/iPod/iPhone is not
installed properly.
Remove your iPad/iPod/iPhone from the dock
and check for obstruction on the connectors in
the dock and on your iPad/iPod/iPhone. Then
reseat it on the dock.
Your iPad/iPod/iPhone is
locked up.
Please make sure that your iPad/iPod/iPhone
is working properly before docking into the
unit. Please refer to your iPad/iPod/iPhone
manual for info on resetting the
iPad/iPod/iPhone. iPad/iPod/iPhone
does not respond to
the speaker system.
Unit not in
iPad/iPod/iPhone mode Make sure the function is set to
iPad/iPod/iPhone mode.
iPad/iPod/iPhone is not
installed properly.
Remove your iPad/iPod/iPhone from the dock
and check for obstruction on the connectors in
the dock and on your iPad/iPod/iPhone. Then
reseat it in the dock.
iPad/iPod/iPhone
does not charge.
iPad/iPod/iPhone is locked
up/ frozen.
iPad/iPod/iPhone battery
has problem. Please make sure your iPad/iPod/iPhone is
working properly before docking into the unit.
Please refer to your iPad/iPod/iPhone manual
for details on resetting.
Remote control
No functions or short
range.
Battery exhausted
- Insert new batteries.
- Aim remote directly towards the remote
sensor.