Jensen JIPS-290I - Manual (Page 6)

6
REMOTE CONTROL
The remote control works on one 3V "CR2025 type" lithium battery
(included). To active the remote control, remove the insulation tab
inserted in the battery compartment. To remove the tab, pull it in the
direction of the arrow as shown in the illustration.
If the operation of the remote control becomes unsatisfactory, replace
the original battery with a new 3-volt lithium battery of the same type.
1. Slide out the battery holder from the remote control case. (Push tab
"A" towards the middle first, see diagram).
2. Replace the weak/dead battery with a new one. Be sure the battery is
installed correctly. The remote control will not work if the battery is
installed with wrong polarity,
CAUTION: Danger of explosion if the battery is replaced incorrectly.
Replace only with the same or equivalent type of battery.
3. Insert the battery holder back into the battery slot.
NOTE: Only use a well-known brand of cell battery to ensure the longest life and best
performance.
BATTERY CARE
i.
If the unit is not used for an extended period of time, remove the battery. An old or leaking
battery can cause damage to the unit and may void the warranty.
ii. Do not dispose batteries in fire. Batteries may leak or explode.
iii. Do not try to recharge batteries that are not intended to be recharged; they can overheat,
rupture and leak (Follow battery manufacturer’s directions).
iv. Only an adult should replace the battery. Do not leave it lying around where a young child or
pet could play with or swallow it.
LOCATION OF CONTROLS
FRONT PANEL OF THE UNIT