JVC VS-DT88V - Manual (Page 19)

16
Using the Tuner
Englis
h
● Auto Tuning
If you press and hold the
4 PREV. or NEXT ¢
( or ) button for one second or more, the fre-
quency changes down, or up, automatically until a
station is found.
OR
● Preset Tuning using the Remote Control
(Possible only after presetting stations)
Select the desired preset number using the Number
buttons on the Remote Control. (For the preset num-
ber more than 10, press the +10 button then the Num-
ber button.) After 1 second the display will show the
preset number’s band and frequency.
Example:
Press the +10 button then the 2 button continuously.
The preset number 12 “P12” appears.
• In AM broadcast, reception sensitivity will be changed by
turning the AM loop antenna. Turn the AM loop antenna
for best reception.
Presetting Stations
(Using the Remote Control)
You can preset up to 30 FM stations and up to 15 AM sta-
tions.
• Preset numbers may have been set to factory test
frequencies prior to shipment. This is not a malfunction.
You can preset the stations you want into memory by
following one of the presetting methods below.
Manual Presetting
1 Select a band by pressing the FM/AM
button.
2 Press the
4 PREV. or NEXT ¢
( or ) button to tune in a station.
3 Press the SET button.
“SET” will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When “SET” stops blinking and disappears after
5 seconds, press the SET button again.
4 Press the > or < button within 5 seconds
to select the preset number.
> or < button: Increase or decrease the preset
number by 1.
Pressing and holding the button
will rapidly increase or decrease
the preset number.
5 Press the SET button within 5 seconds.
“STORED” appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6 Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations, repeat the same
steps as above.
CAUTION:
• Even if the system is unplugged or if the
power failure occurs, the preset stations
will be stored for about 24 hours. However,
in case the preset stations are erased, you
will need to preset the stations again.
To Change the FM Reception
Mode
(Using the Remote Control)
When you are tuned into an FM stereo broadcast, the
“STEREO” indicator appears and you can hear stereo
effects.
If an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you
lose stereo effect.
Press the FM MODE button so that the “MONO”
indicator appears on the display.
To restore the stereo effect, press the FM MODE
button so that the “MONO” indicator goes out.
10 + 2
(After 1 second)
STORED
SET
SET
SET
FM/AM PREV. NEXT VCD No. VCD No.
When changing
the Band
FM = 30, AM = 15
or
MONO
FM
MODE
VS-DT68V-88V[UF]_EN.book Page 16 Wednesday, June 26, 2002 3:31 PM