JVC UX-L30 - Manual (Page 12)

– 9 –
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. When you plug the AC power cord into the wall
outlet, “0:00” starts flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Press UP or DOWN to adjust the
hour, then press CLOCK/TIMER.
The minute digits start flashing on the display.
3
Press UP or DOWN to adjust the minute,
then press CLOCK/TIMER.
To check the clock time during play
On the remote control ONLY:
Press DISPLAY.
• Each time you press the button, the source
indication and the clock time alternate on the display.
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to “0:00” right away. If this happens, set the
clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, set the clock again.
To adjust the clock again
1 Make sure (timer) indicator is not lit on the display.
• If it is lit, press and hold CLOCK/TIMER until it goes
off.
2 Press CLOCK/TIMER repeatedly until the unit enters
the clock setting mode (the hour digit start flashing on
the display).
First time you press CLOCK/TIMER, the unit enters the
timer setting mode.
• See pages 19 and 20.
3 Repeat steps 2 and 3 of the procedure of “Setting the
Clock.”
4 Press and hold CLOCK/TIMER again so that
(timer) indicator goes off from the display.
Turning On the Power
When you press the play button—CD 3/8, TAPE 2 3,
FM/AM and AUX/MD, the unit automatically turns on and
starts playback if the source is ready.
To turn on the unit, press
STANDBY/ON
.
The STANDBY/ON lamp lights
green and “HELLO” appears on the
display.
To turn off the unit (on standby), press
STANDBY/ON
again.
The STANDBY/ON lamp lights red and “GOOD BYE”
appears on the display.
• “0:00” flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is on standby.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 11) will be erased in a few days.
Selecting the Sources and Starting Play
To play back CDs, press CD
3/8. (See pages 13 – 15.)
To play back tapes, press TAPE 2 3. (See page 16.)
To listen to FM/AM (MW/LW) broadcasts, press FM/AM.
(See pages 9 – 10.)
To select the external equipment as the source, press
AUX/MD.
When you press the play button for a particular source
(CD
3/8, TAPE 2 3, FM/AM and AUX/MD), the unit turns
on (and the unit starts playing the source if it is ready).
DISPLAY
CLOCK
/TIMER
CLOCK/TIMER
UP
DOWN
CLOCK
/TIMER
UP DOWN
CLOCK/TIMER
CD
3/8
TAPE
23
FM/AM AUX/MD
STANDBY/ON
STANDBY / ON
EN01-12_UX-L30[A]f 02.3.4, 9:07 PM 9