JVC UX-L30 - Manual (Page 15)

– 12 –
Tuning in to a Preset Station
On the remote control ONLY:
1
Press FM/AM to select the band.
The unit automatically turns on and tunes in to
the previously received station (either FM or
AM—MW/LW).
• Each time you press the button, the band alternates
between FM and AM (MW/LW).
2
Press UP or DOWN to select a
preset number.
To tune a preset number directly using the number
buttons
On the remote control ONLY:
Pressing the number button(s) allows
you to select a preset number you want.
Ex.:
For preset number 5, press 5.
For preset number 15, press +10,
then 5.
For preset number 20, press +10,
then 10.
For preset number 30, press +10,
+10, then 10.
FM/AM
UP
DOWN
To preset stations manually—Manual Presetting
You need to preset stations separately for the FM and AM
(MW/LW) bands.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
On the remote control ONLY:
1
Tune in to the station you want to preset.
• See “Tuning in to a Station” on page 11.
2
Press SET.
3
Press UP or DOWN to select a
preset number.
4
Press SET again.
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The tuner preset stations will be erased in a few days. If this
happens, preset the stations again.
SET
SET
UP
DOWN
1
4
7
10
2
5
8
3
6
9
+10
EN01-12_UX-L30[A]f 02.3.4, 9:08 PM 12