JVC UX-L30 - Manual (Page 19)

– 16 –
Playing Back Tapes
You can play back type I, type II, and type IV tapes without
changing any settings.
Playing Back a Tape
1
Press
0 PUSH OPEN on the unit.
2
Put a cassette in with the exposed part of the
tape down.
3
Press
0 PUSH OPEN again.
4
Press TAPE
2 3.
The unit automatically turns on and the tape
starts playing. The tape direction indicator
(
3 or 2) flashes slowly on the display.
• Each time you press the button, the tape
direction changes.
3 : plays the front side.
2 : plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to
or . (See “To
play both sides—Reverse Mode.”)
If no cassette is inserted
“NO TAPE” appears on the display.
To stop playing, press 7.
To fast-wind to the left or to the right, press ¢ or 4
while the tape is not running.
The tape direction indicator (
3 or 2) starts flashing quickly
on the display.
To remove the cassette, press
0 PUSH OPEN on the unit.
To play both sides—Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
Press REV.MODE.
• Each time you press the button, reverse mode
changes as follows:
: The deck automatically stops after
playing both sides of the tape. Stops when
playback in the
2 direction is finished.
: The deck continues to play both sides of the
tape until
7 is pressed.
: The deck automatically stops after playing one
side of the tape.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
PUSH
OPEN
0
TAPE
23
TAPE
REV.MODE
REV. MODE
EN13-16_UX-L30[A]f 02.3.4, 9:08 PM 16