Jensen KT2012 - Manual (Page 4)

BATTERIES CAUTIONARY INSTRUCTIONS
CAUTION – To Reduce the Risk of Fire or injury to Persons, Read and Follow
these instructions.
1. Use only the following type and size of battery: 4 ‘C’ size (UM-2) alkaline batteries.
2. Do not dispose of the battery in a fire. The cell may explode. Check with local
codes for possible special disposal instructions.
3. Do not open or mutilate the battery. Released electrolyte is corrosive and may
cause damage to the eyes and skin. It may be toxic if swallowed.
4. Exercise care in handling batteries in order not to short the battery with conductor
material such as rings, bracelets, and keys. The battery or conductor may overheat
and cause burns.
5. Do not attempt to recharge the battery provided with or identified for use with this
product by heating them. The batteries may leak corrosive electrolyte or explode.
6. Do not attempt to rejuvenate the battery provided with or identified for use with this
product by heating them. Sudden release of the battery electrolyte may occur
causing burns or irritation to eyes or skin.
7. All batteries should be replaced at the same time. Mixing fresh and discharged
batteries could increase internal cell pressure and rupture the discharged batteries.
8. When inserting batteries into this product, the proper polarity or direction must be
observed. Reverse insertion of batteries can cause charging, which may result in
leakage and explosion.
9. Remove the batteries from this product if it will not be used for a long period of time
(several months or more) since during this time the battery could leak, damaging in
the product.
10. Discard “dead” batteries as soon as possible since “dead” batteries are more likely
to leak in a product.
11. Do not store this product, or the batteries provided with or identified for use with this
product in high-temperature areas. Batteries that are stored in a freezer or
refrigerator for the purpose of extending shelf life should be protected from
condensation during the storage and defrosting. Batteries should be stabilized at
room temperature prior to use after storage.
12. Do not mix old and new batteries or different types of batteries. Do not mix alkaline,
standard (Carbon-Zinc) or rechargeable (Nickel-Cadmium) batteries.
SAVE THESE INSTRUCTIONS
5
INTRODUCTION TO CALLER ID INSTRUCTIONS
Read this manual carefully before using this product.
Congratulations on your purchase of this product! The unit allows you to take
advantage of the Caller Identification service that may be offered by your local
telephone company. Not all local telephone companies provide Caller Identification
service, therefore you must make sure the service is available.
IMPORTANT: For your Caller ID to function, you must first contact your local
telephone company to arrange to have Caller ID service installed on your line.
There will be an extra charge added to your monthly telephone bill for this
service. Please consult with your local telephone company for the Caller ID
service charge.
1. The Caller ID function can be used to screen unwanted calls, eliminate harassment
from annoying calls, or to return missed calls using the displayed speed dial feature.
2. When used with Caller ID service, the unit displays the name and telephone number
of the person calling, along with the date and time of the call before you pick up your
telephone.
6