Jensen KT2012 - Manual (Page 8)

14
If you are in a Pulse dialing area you
may still take advantage of touch-tone
services after dialing to respond to
touch-tone prompts. To do this, press
the */TONE button to temporarily
change the dialing mode from Pulse to
Tone after dialing in the Pulse mode.
This will enable Pulse users to access
touch-tone services. It will revert back to
Pulse after hanging up. If you subscribe to Call Waiting through
your local phone company, and you
receive another phone call. Simply
press the FLASH button to answer the
new call. Press the FLASH button again
to return to the original call.
STORING AND REDIALING NUMBERS IN THE SPEED-DIAL MEMORY
This telephone has ten speed-dial memories to store up to 10 of your most frequently
called numbers for easy two-touch redialing. Each of the 10 memories can store
numbers of up to 16 digits. HOWEVER, ONLY THE LAST 14 DIGITS WILL APPEAR
IN THE DISPLAY
IMPORTANT:You must lift the handset from the cradle to store numbers in the
memory. After a few seconds off the cradle, you will hear the “off the hook/hang up”
warning signal from the phone company. Therefore, if you are going to store more
than one number at a time, please disconnect the straight cord from the wall jack to
avoid the “off the hook/hang up” warning signal. REMEMBER TO RECONNECT THE
STRAIGHT CORD AFTER YOU FINISH STORING YOUR NUMBERS.
TO STORE
Lift the handset and press the STORE
button. The “STORE” indicator will
appear in the display. Use the number keys to enter the first
area code and number that you wish to
store. Remember to enter the number
“1” if necessary. The numbers will
appear in the display as you dial them.
NOTE:If you make a mistake while
entering the number, depress the Hook
switch to clear the display and then
start with step 1 again.
BASIC OPERATIONS (CONTINUED)
13
OFF/LO/HI RINGER SWITCH
Slide the OFF/LO/HI Ringer switch to
the HI or LO position to turn the ringer
on. Slide the OFF/LO/HI Ringer switch to
the OFF position to turn the ringer off.
Slide the TONE/PULSE switch to TONE
or PULSE to match the service provided
on your telephone line. If you are not
sure of your service, please contact your
telephone company. To increase/decrease the handset’s
volume, slide the RECEIVER Volume
switch to the NORMAL (N) or HIGH (H)
position.
Press the REDIAL button to automatically
redial the last number dialed.
NOTE:Please note that only the last
number you called on this handset can
be stored in the Redial memory. Press the FLASH button to hang up the
phone without having to return it to the
base. If you subscribe to call waiting,
FLASH button is also used to switch
between calls.
BASIC OPERATIONS (CONTINUED)