Jensen KT2012 - Manual (Page 9)

15
Verify that the number on the display is
correct, then press the STORE button
again. The Memory indicator (“MEM”)
will appear in the display. Press the number “1” button to store the
displayed number in memory location 1.
Repeat steps 1 through 4 to store up to
nine additional numbers in memories “2”
through “0”
TO CHANGE A STORED NUMBER:
To change one of the stored numbers, simply follow the procedures in steps 1
through 5 and enter a new phone number in the desired memory. The new phone
number will be memorized and the previous phone number will be erased from the
memory.
NOTE:For your convenience, you may write the names of the people whose numbers
you stored on the small index card in the center of the cradle.
MESSAGE WAITING FUNCTION
Lift the handset and listen for a dial
tone. Press the MEMO button and then press
one of the number keys, “1” through “0”,
corresponding to the memory location
you want to dial. The stored number will
be dialed automatically.
TO REDIAL A STORED NUMBER
BASIC OPERATIONS (CONTINUED)
When a caller has recorded a message
on a personal message service, “ ”
will appear in the display and will go out
when you retrieve your message.
This feature is only for subscribers of
a voice mail message waiting
service through the local phone
company.
VIEWING THE CALLER ID MEMORY
To view the new calls (NEW CALL
indicator will blink), press the [
▼] or [▲]
button. As they are checked, the CALL
# will decrease.
When all new calls have been checked,
“END OF NEW CALL” will appear in the
display. Press the [
▼] to view the oldest
calls or the [ ▲] button to view the most
recent calls.
NOTES:
•After all calls are viewed, “END OF LIST” will appear in the display.
•The NEW CALL indicator will blink until all new caller ID information has been
reviewed.
•The RPT icon will appear in the display if you have received multiple new calls from
the same number.
•If you receive a call from a number previously viewed in the caller ID memory, the
data in memory will be replaced with the new call’s time and date, and the NEW icon
will light in the display.
•If no key is pressed within 20 seconds, the display will revert to normal display and
show the total call counter, new call counter, current time and date.
ERASING THE CALLER ID MEMORY
To erase a single call, press the [ ▼] or
[ ▲] button to select the call to delete,
then press the ERASE button twice
quickly. The information for that call will
be erased and the call # and caller ID
data will be updated.
ALL NEW CALLS MUST BE
REVIEWED BEFORE ERASING
CALLER ID MEMORY. To erase all calls
in caller ID memory, press and hold the
ERASE button for three seconds. The
message “ERASE ALL CALLS” will
appear in the display. Press the ERASE
button again to confirm. All caller ID
information will be deleted and “NO
CALLS” will appear in the display.
16
BASIC OPERATIONS (CONTINUED)