Jensen KT2012 - Manual (Page 6)

9
HANDSET BOTTOM OF BASE
1.Receiver
2.Hook Switch
3.TONE/PULSE Switch
4.Key Buttons (0-9,*,#)
5.MEMO Button
6.STORE Button
7.Transmitter
8.RECEIVER (NORMAL/HIGH) Volume Switch
9.REDIAL Button
10.FLASH Button
11.Battery Compartment
12.DC IN Jack
13.OFF/LO/HI Ringer Switch
14.Handset Jack
15.Line In Jack
LOCATION OF CONTROLS (CONTINUED)
10
LOCATION OF CONTROLS (CONTINUED)
CAUTION
Disconnect the telephone line from the equipment before replacing batteries.
BATTERY INSTALLATION
When the batteries become weak, the battery icon ( ) will appear in the display.
Replace as described below. You must replace the
batteries within two minutes, or the caller ID and
memories will be lost.
Insert four (4) “C” size (UM-2) batteries (not included) in
this unit to use the Caller ID and telephone functions
as follows:
1.Open the battery door by pulling back on the latch.
2.Insert four (4) “C” size (UM-2) alkaline batteries
(not included).
3.Snap the battery door back into place.
AC OPERATION
To operate the unit using AC power, connect the included AC adaptor to the DC jack
on the bottom of the base and to a wall outlet having 120V, 60Hz AC only. The
batteries will work as battery back-up in the event of power failure and will keep all of
the functions without interruption. Make sure to only use the supplied adaptor, 6V
300mA with positive center ( ).
This unit can be used on a desk, or other level surface
away from excessive heat or direct sunlight.
1. Set the OFF/LO/HI Ringer switch to LO or HI
to have the ringer sound when receiving a phone call.
2. Set the TONE/PULSE switch to TONE or
PULSE to match the service provided on
your telephone line. If you are not sure of
your service, please contact your
telephone company.
3. DO NOT CONNECT TO THE
TELEPHONE LINE UNTIL CALLER ID
SETUP IS COMPLETED. Connect the
coiled cord to the handset and base.
Connect the long telephone cord into the jack on the bottom of the base, thread it
through the groove toward the back of the base.