JVC CA-MXK30R - Manual (Page 32)

29
Troubleshooting
• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.
Symptom Possible Cause Action
No sound is heard. • Connections are incorrect, or loose.
• Headphones are connected.
• Check all connections and make cor-
rections. (See pages 4 to 6.)
• Disconnect the headphones.
Poor radio reception • The antenna is disconnected.
• The AM Loop Antenna is too close
to the System.
• The FM Wire Antenna is not prop-
erly extended and positioned.
• Reconnect the antenna securely.
• Change the position and direction of
the AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
The disc tray does not open. • The AC power cord is not plugged in.
• Tray is locked. • Plug the AC power cord.
• Unlock the tray. (See page 18.)
The CD skips. The CD is dirty or scratched. Clean or replace the CD. (See page 28.)
The CD does not play. The CD is upside down. Put the CD in with the label side up.
The cassette holder cannot be opened. During tape playing, the power cord
was unplugged. Plug in the power cord, and turn on the
System.
Unable to record. Cassette record protect tabs are removed. Cover holes on back edge of cassette with tape.
Unable to operate the Remote Control. • The path between the Remote Control
and the sensor on the Unit is blocked.
• The batteries have lost their charge.
• Remove the obstruction.
• Replace the batteries.
Operations are disabled. The built-in microprocessor has malfunc-
tioned due to external electrical interference. Unplug the System then plug it back in.
Specifications
Amplifier
Output Power
CA-MXK30R 60 W per channel, min. RMS, driven into
6 Ω at 1kHz, with no more than 10% total
harmonic distortion (IEC268-3)
45 W per channel, min. RMS, driven into
6
Ω at 1kHz, with no more than 0.9% to-
tal hermonic distortion (DIN)
CA-MXK10R 30 W per channel, min. RMS, driven into
6 Ω at 1kHz, with no more than 10% total
harmonic distortion (IEC268-3)
25 W per channel, min. RMS, driven into
6
Ω at 1kHz, with no more than 0.9% to-
tal hermonic distortion (DIN)
Input Sensitivity/Impedance (1 kHz)
AUX IN 300 mV/50 k Ω
Speaker terminals 6 - 16 Ω
Phones 32 Ω - 1 kΩ
15 mW/ch output into 32 Ω
Cassette Deck Section
Frequency Response
Type I (NORMAL) 63 - 12 500 Hz
Wow And Flutter 0.15% (WRMS)
CD Player
CD Capacity 3 CDs
Dynamic Range 85 dB
Signal-To-Noise Ratio 90 dB
Wow And Flutter Unmeasurable
Tuner
FM Tuner
Tuning Range 87.50 MHz - 108.00 MHz
AM Tuner
Tuning Range (MW) 522 kHz - 1 629 kHz
(LW) 144 kHz - 288 kHz
Unit
Dimensions
CA-MXK30R 270 mm ✕ 305 mm ✕ 430 mm (W/H/D)
CA-MXK10R 270 mm ✕ 305 mm ✕ 386 mm (W/H/D)
Mass
CA-MXK30R Approx. 7.5 kg
CA-MXK10R Approx. 6.6 kg
Accessories
AM (MW/LW) Loop Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
Power Specifications
Power Requirements AC 230 V , 50 Hz
Power Consumption
CA-MXK30R 105 W (power on mode)
10 W (in Standby mode)
Approx. 1 W (in ECO mode)
CA-MXK10R 65 W (power on mode)
8 W (in Standby mode)
Approx. 1 W (in ECO mode)
Design and specifications are subject to change without notice.
VICTOR COMPANY OF JAPAN, LIMITED EN 0402NNMCREBET
Body.fm Page 29 Thursday, April 18, 2002 3:34 PM