Jacuzzi J-DREAM II - Manual (Page 29)

27
FIGURE 1. CONTROL PANEL AND DISPLAY
FIGURE 2. MIXER CONTROL
Part II: Operating Instructions
CONTROL PANEL
System control is provided by the electronic display located inside the shower cabin (see Figure 1)
The display is used to start up the five functions of the unit: the shower, the cascade waterfall, the hydromassage (all jets),
hydromassage (pulsed jets), and the steam bath. The display is composed of clear symbols to identify the five functions.
Starting Any Function
The mixer control valve must be ON for the functions of the
control panel to be operational except for the steam function .
After the mixer valve has been set and is ON, press any button
to start that function. The steam function can be ON with any
other function. Other functions can only be ON one at a time.
Pressing the OFF button turns all functions OFF.
Mixer Control
To adjust the temperature turn the mixer handle as shown in
Figure 2. When exiting the J-Dream with all functions OFF, the
mixer control must be turned to the OFF position.
HOT
COLD
OFF
Shower
The shower button has four modes: pressing once activates one shower, pressing twice activates the other shower only, pressing
a third time activates both showers and pressing a fourth time deactivates both showers. Pressing the OFF button or any other
button will turn the shower mode OFF regardless if one or the other or both showers are operating.
Cascade
This feature offers the pleasant sensation of a waterfall lapping over your shoulders and body as you are comfortably seated. To
start the cascade, press the CASCADE button on the display (Figure 1) to automatically start water delivery from the nozzles above
the seats. To stop the cascade, press the CASCADE button again or OFF button or any other button.
OFF BUTTON CASCADE
START BUTTON
HAND HELD SHOWER
START BUTTON
PULSED JETS
START BUTTON
JETS
START BUTTON
STEAM
START BUTTON
OFF
WHIRLPOOL BATH
R