Jacuzzi J-DREAM II - Manual (Page 32)

Printed in the U.S.A. Printed on Recycled Paper
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
©1997 Jacuzzi Whirlpool Bath K922000 8/13/04
Jacuzzi Whirlpool Bath
P.O. Box 702168, Dallas, TX 75370-2168
Service Support: Call (800) 288-4002
Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of this type.
It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of this product. Jacuzzi Whirlpool
Bath makes no representation or warranty regarding, and will not be responsible for any code compliance.
Troubleshooting Chart
1. Control is on and appears to
be functioning, but no steam. A. Allow 2 minutes for steam to
flow.
B. Replace water filter, drain and
flush out steamer and steam
plumbing. Pour six ounces of
water into the steam delivery
tube. Reset high limit safety
switch.
A. Replace water filter, drain and
flush out steamer and steam
plumbing. Pour six ounces of
water into the steam delivery
tube. Reset high limit safety
switch.
A. Replace water filter, drain and
flush out steamer and steam
plumbing. Pour six ounces of
water into the steam delivery
tube.
2. Steam generator will fill
and produce steam, but will
boil water away without
refilling and shut itself off.
3. Excess water is exhausted
from the steam head.
A. Steamer heating up.
B. High limit safety switch tripped.
A. There is a high concentration of
mineral buildup in the tank
water because of continued use
without draining the tank. This
causes faulty water fill opera-
tion, and the high temperature
safety switch will trip.
A. There is a high concentration of
mineral buildup in the tank.
PROBABLE CAUSE PROBLEM REMEDY
30