Jacuzzi J-DREAM II - Manual (Page 30)

Starting the Hydromassage
The J-Dream allows you to enjoy the benefits of a real hydromassage. The hydromassage is created by the
combined action of 16 water jets (four sets of 4 ). The action of each group of jets is either alternated or pulsed.
To start the hydromassage jets, press the JETS button once (Figure 1). This will activate the jets on one wall.
Pressing it a second time will shut OFF that wall and activate the other wall. Pressing a third time activates both walls
and pressing a fourth time turns the hydromassage OFF. The PULSED JETS button may be pushed with either wall
or both walls on. Pressing this button once will increase the rate of the pulses from a default speed. Pressing a second
and third time continues to increase the rate of pulsation. Pressing a fourth time reverts to the default rate. To stop
the hydromassage in any mode, press the OFF button or any other button.
Starting the Steam Bath
Press the STEAM start button on the display (Figure 1). The steam function has a 60 minute cycle after which it turns
off automatically. The steam bath can be turned off at any time by depressing the OFF button. Do NOT operate the
steam generators without the water supply ON as permanent damage to the generators will occur.
CD/RADIO
For operation of the CD/radio consult the manual enclosed.
NOTE: In order to hear the TV audio, the Pioneer CD Receiver AUX function must be setup to be ON.
To perform this setting:
• If the unit is on, press SOURCE and hold until the unit turns off.
• Press FUNCTION repeatedly until AUX appears in he display
• Select AUX on and off with . The status will be displayed: AUX :ON.
If power to the unit is interrupted, the CD Receiver will have to be reset.
Note:For units with AM/FM radios, the quality of AM reception will vary by locality. Jacuzzi Whirlpool Bath is not
responsible for the quality of AM reception.
Maintenance
Routine Maintenance
The shower head is equipped with a filter which must be occasionally cleaned of limestone and other deposits. The
filter is placed between the flexible hose and the shower head. If limestone deposits are on the jet nozzles, the shape
of the water jets may be altered. Remove and clean the nozzles occasionally. Unscrew the nozzle to remove. Clean
it by soaking it in a moderate vinegar and water solution. Do not use metal tools (such as scissors or screwdrivers,
etc.) to clean the nozzle. For routine cleaning of the dome and plastic surfaces, such as the side panel, the shower
wall panel, etc., use a mild liquid detergent only. Any normal polish can be used to keep acrylic surfaces shiny. The
glass panels can be cleaned with any glass-cleaning product available on the market. Do not use abrasives, alcohol,
acetone, ammonia or other solvents on any part of the J-Dream.
28