JVC SR-MV30 - Manual (Page 48)

Filename [SR-MV30U_07VCR Operation.fm]
Masterpage:Left+
48
EN
Page 48 March 30, 2004 5:46 pm
OPERATIONS ON VCR DECK
Still Picture/Frame-By-Frame Playback
1
Press 9 to pause during playback.
2
Press 9 to activate frame-by-frame playback.
● To resume normal playback, press 4.
Slow Motion
1
Press 9 to pause during playback.
2
Press and hold 9 for 2 seconds, then release. Press 9 and
release again to return to still picture.
● The speed changes for each direction by pressing 3 and 5
repeatedly.
● To resume normal playback, press 4.
High-Speed Search
During playback, press 5 for forward high-speed search, or 3
for reverse high-speed search.
● Each press of the button increases the search speed for each
direction.
When pressing 5:
(SP): +5x{+7x
(EP): +11x{+21x
When pressing 3:
Once 3 is pressed, reverse search starts in –1x normal playback
speed. After this process, each press of 3 changes the search
speed between –5x and –7x in SP mode, –11x and –21x in EP mode.
(SP): –1x]–5x{–7x
(EP): –1x]–11x{–21x
● To resume normal playback, press 4.
Quick Rewind A Little
During playback (or Live Memory Playback), press . The unit
rewinds the picture a little (about 7 seconds) and resumes
playback.
● If the button is pressed repeatedly, the unit rewinds the pictures
continuously and resumes playback.
Skip Search
During playback, press 1 to 6 times to skip over unwanted
sections.
● Each press initiates an approximately 30-second period of fast-
motion playback. Normal playback resumes automatically.
● To resume normal playback, press 4.
Index Search
Your unit automatically marks index
codes at the beginning of each
recording. This function gives you
quick access to any one of 9 index
codes in either direction.
NOTE:
Before starting, make sure the unit is in
the Stop mode.
Press 2 or 6 to activate Index Search. “INDEX –1” or
“INDEX 1” is displayed on the TV screen and search begins in the
corresponding direction.
● To access index codes 2 through 9, press 2 or 6 repeatedly
until the correct index number is displayed.
Example:
To locate the beginning of B from the current position, press 2
twice.
To locate the beginning of D from the current position, press 6
once.
● When the specified index code is located, playback begins
automatically.
Playback Features
● Turn on the unit.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/CABLE/DBS/DVD switch to DVD.
● Press VCR/DVD repeatedly so that the VCR lamp lights up on the
unit.
ATTENTION:
In the search, still, slow-motion or frame-by-frame playback mode,
● the picture will be distorted.
● the noise bars will appear.
● there may be a loss of color.
● you cannot hear the sound.
1
4
7
2
5
8
0
6
9
5 3
2
4
6
9 8
REC MODE
AUDIO
CH +/–
VCR/DVD
1
Current position
Index number
SR-MV30U_00.book Page 48 Tuesday, March 30, 2004 5:46 PM