JVC SR-MV30 - Manual (Page 80)

Filename [SR-MV30U_10Subsidiary.fm]
Masterpage:Left+
80
EN
Page 80 March 30, 2004 5:46 pm
SUBSIDIARY SETTINGS
If you connect the unit and TV with Component Video Connection
(
੬ pg. 17), you can select the scan mode from two modes:
Interlaced scan mode which is used in the conventional TV
system, and Progressive scan mode which enables reproduction of
higher-quality images. For details, refer to “GLOSSARY”
(
੬ pg. 86).
1
Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
2
Press PROGRESSIVE SCAN for 3 or more seconds.
● Video output indicator ( ) lights on the front display panel if
Progressive scan mode has been established. (
੬ pg. 14)
● Each press of PROGRESSIVE SCAN for 3 or more seconds
switches the scan mode.
NOTES:
● When the Progressive scan mode is engaged, no video signal is
output from AUDIO/VIDEO and S-VIDEO OUTPUT connectors.
● Interlaced scan mode is the setting at your purchase.
● Interlaced scan mode might be suitable depending on video material.
● Scan mode cannot be set while menu screen is displayed.
You can lock the disc tray to prohibit the unwanted disc ejection by
children.
To lock tray
While the unit is turned off, press and hold 8, then press x
(OPEN/CLOSE) on the unit. “LOCKED” appears on the front
display panel and the disc tray is locked.
To unlock tray
While the unit is turned off, press and hold 8, then press x
(OPEN/CLOSE) on the unit. “UNLOCK” appears on the front
display panel.
Scan Mode Set
ATTENTION:
Your TV needs to be compatible with Progressive.
● Turn on the unit.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/CABLE/DBS/DVD switch to DVD.
Watch the image on VCR deck in the Progressive scan
mode via component video
A Set the Progressive-compatible TV to the component input
mode.
B Press VCR/DVD repeatedly so that the DVD lamp lights up
on the unit, then press PROGRESSIVE SCAN for 3 or more
seconds so that the Video output indicator (
) lights on the front
display panel.
C Press VCR/DVD repeatedly so that the VCR lamp lights up
on the unit.
D Press VCR].
● “VCR]” lights up on the unit.
NOTES:
● Be sure to engage the DVD deck in stop mode.
● It is not possible to perform the above steps when the DVD deck is
in timer standby mode.
1
4
7
2
5
8
0
3
6
9
PROGRESSIVE SCAN
VCR/DVD
Tray Lock (DVD Deck Only)
● Turn off the unit.
8 x
SR-MV30U_00.book Page 80 Tuesday, March 30, 2004 5:46 PM