JVC RX-7520VBK - Manual (Page 29)

26
English Before you start, remember....
• Make sure that you have set the speaker information correctly (see pages 16 to 18).
• You cannot adjust the center speaker output level when you have set “CNTR SP” to “NONE.”
• You cannot adjust the rear speaker output levels when you have set “REAR SP” to “NONE.”
• Remember not to change the speaker setting while using any Surround modes; otherwise, it may be canceled when you deactivate the
speakers required for the Surround mode.
Front Panel
ADJUST
RX-7520V AUDIO/VIDEO CONTROL RECEIVER
SETTING
MASTER VOLUME
CONTROL DOWN UP SURROUND MODE
PHONES
SURROUND ON/OFF
FM/AM TUNING
STANDBY
FM/AM PRESET FM MODE
MEMORY
STANDBY/ON
DVD VCR TV SOUND
CD TAPE/CDR
SOURCE NAME
AM
DVD MULTI
FM
BASS BOOST INPUT ANALOG/DIGITAL
SPEAKERS ON/OFF
INPUT ATT
1 2
L C S.WFR LS RS CH- S LFE
SPK PRO LOGIC ΙΙ DSP H.PHONE AUTO MUTING TUNED STEREO VOLUME BASS BOOST INPUT ATT SLEEP DIGITAL AUTO ANALOG
DIGITAL LINEAR PCM
1 2 R
Creating Realistic Sound Fields
Remote Control
FM MODE
PTY–PTY SEARCH–PTY
Using Dolby Pro Logic II, Dolby Digital
and DTS Digital Surround
Once you have adjusted the Surround modes, the adjustment is
memorized for each source.
• When playing back digital multichannel software (Dolby Digital
5.1 ch or DTS Digital Surround), the SURROUND MODE button
does not work.
From the remote control:
It will be convenient for you to use the remote control for
adjustments, since you can make adjustments from your listening
point, by using the test signal.
• For selecting Panorama mode for Pro Logic II Music, use the
button on the front panel.
1
Set the analog or digital input mode for the
source you like to listen and start playing.
When playing back software encoded with Dolby Digital and DTS
Digital Surround, select the digital input mode (see page 14).
2
Press SURROUND ON/OFF to
activate Surround mode.
Each time you press the button, Surround mode
turns on and off alternately.
• If you are playing back software encoded with Dolby Digital
multichannel, “DOLBY DIGITAL” is selected.
• If you are playing back software encoded with DTS Digital
Surround, “DTS SURROUND” is selected.
• If you are playing back any software other
than above, you can select “PL II MUSIC” or
“PL II MOVIE” according to the source by
pressing SURROUND MODE. (
PRO LOGIC
II indicator lights up on the display.)
If you like to adjust sound, go to step 3.
TEST
EFFECT
SOUND
SURROUND
MODE
SURROUND
ON/OFF
CENTER +/–
REAR•L +/–
REAR•R +/–
ADJUST SURROUND
MODE SURROUND
ON/OFF CONTROL
UP
5/DOWN ∞
Display
SURROUND
ON/OFF
SURROUND
MODE
EN23-29.RX-7520V[C]f.pm5 02.2.14, 4:32 PM 26