JVC RX-7520VBK - Manual (Page 32)

29
English
On the front panel:
1
Start playing 2 channel software—either analog
or Linear PCM—and select the source.
2
Press SURROUND ON/OFF to
activate Surround mode.
When Surround mode turns on, the last selected
Surround mode will be activated.
• Each time you press the button, Surround mode
turns on and off alternately.
3
Press SURROUND MODE repeatedly
until one of the DAP modes—“LIVE
CLUB,” “DANCE CLUB,” “HALL”
and “PAVILION”—or “ALL CH STEREO”
appears on the display.
The DSP indicator also lights up on the display.
If you like to adjust sound, go to step 4.
4
Adjust the speaker output levels.
1) Press ADJUST repeatedly until one
of the following indications (with the
current setting)* appears on the
display.
REAR L : To adjust the left rear speaker output level
(–10 to +10).
REAR R : To adjust the right rear speaker output level
(–10 to +10).
CENTER : For “ALL CH STEREO” only—to adjust the
center speaker output level
(–10 to +10).
* “0” is the initial setting. If you have already changed the
setting, another number (level) will be shown.
2) Press CONTROL UP 5/DOWN ∞
to adjust the selected speaker
output levels.
3) Repeat steps 1) and 2) to adjust the other
speaker levels.
5
For DAP modes only: Adjust the effect level.
1) Press ADJUST repeatedly until
“EFFECT” (with the current
setting)* appears on the display.
* “EFFECT 3” is the initial setting. If you have already
changed the setting, another setting will be shown.
2) Press CONTROL UP 5/DOWN ∞
to select the effect
level (1 to 5) you want.
• Each time you press the button, the effect
level changes as follows:
As the number increases, the selected mode becomes
stronger (normally set it to “EFFECT 3”).
To cancel DAP modes and All Channel Stereo
Press SURROUND ON/OFF again so that “SURROUND OFF”
appears on the display. The DSP indicator goes off.
EFFECT 1 EFFECT 2 EFFECT 3
EFFECT 4 EFFECT 5
ADJUST SETTIN
CONTROL
DOWN UP
ADJUST SETTING
SURROUND ON/OFF
SURROUND MODE
CONTROL
DOWN UP
EN23-29.RX-7520V[C]f.pm5 02.2.14, 4:33 PM 29