JVC RX-7520VBK - Manual (Page 31)

28
English
Creating Realistic Sound Fields
When you select “PL II MUSIC,” you can go to the
following adjustment.
4
Turn Panorama control on or off.
1) Press ADJUST repeatedly until
“PANORAMA” (with the current
setting)* appears on the display.
* “OFF” is the initial setting. If you have already changed
the setting, “ON” will be shown.
2) Press CONTROL UP 5/DOWN ∞
to turn on or off Panorama control.
• Each time you press the button, “ON” and
“OFF” change alternately.
ON : Select this when you like to enjoy
“wraparound” sound effect with side-wall
image.
OFF : Select this when you like to enjoy
originally recorded sounds.
To cancel Surround mode
Press SURROUND ON/OFF again so that “SURROUND OFF”
appears on the display.
• If Surround mode is canceled while playing back multichannel
digital software, all channel signals are mixed and output through
the front speakers (and subwoofer if you have connected a
subwoofer and set the subwoofer setting correctly—“YES”).
Using DAP Modes and All Channel Stereo
Once you have adjusted the DAP modes and All Channel Stereo, the
adjustment is memorized for each source.
• You cannot use the DAP modes and All Channel Stereo if no rear
speakers are connected.
• You cannot adjust the effect level for “ALL CH STEREO.”
From the remote control:
It will be convenient for you to use the remote control for
adjustments, since you can make adjustments from your listening
point.
1
Start playing 2 channel software—either analog
or Linear PCM—and select the source.
2
Press SURROUND ON/OFF to activate
Surround mode.
When the Surround mode turns on, the last selected
Surround mode will be activated.
• Each time you press the button, Surround mode turns on and
off alternately.
3
Press SURROUND MODE repeatedly
until one of the DAP modes—“LIVE
CLUB,” “DANCE CLUB,” “HALL”
and “PAVILION”—or “ALL CH
STEREO” appears on the display.
The DSP indicator also lights up on the display.
If you like to adjust sound, go to step 4.
4
Press SOUND.
The 10 keys are activated for sound adjustments.
5
Adjust the speakers output levels
(–10 to +10).
• To adjust the left rear speaker level, press
REAR•L +/–.
• To adjust the right rear speaker level, press
REAR•R +/–.
For “ALL CH STEREO” only:
• To adjust the center speaker level, press
CENTER +/–.
6
For DAP modes only:
Press EFFECT to select the effect
level (1 to 5) you want.
• Each time you press the button, the effect
level changes as follows:
As the number increases, the selected mode becomes stronger
(normally set it to “EFFECT 3”).
Remote
NOT
EFFECT 1 EFFECT 2 EFFECT 3
EFFECT 4 EFFECT 5
SURROUND
MODE
SOUND
SURROUND
ON/OFF
EFFECT
4
REAR R
8 9
ADJUST SETTING
REAR L
5 6
CENTER
2 3
L C
S.WFR
LS RS
CH-
S
LFE
SPK
PRO LOGIC ΙΙ DIGITAL AUTO
LINEAR PCM
1
R
CONTROL
DOWN UP
EN23-29.RX-7520V[C]f.pm5 02.2.14, 4:33 PM 28