Juniper Networks ERX-1410 - Manual (Page 96)

CHAPTER 7
Maintaining the ERX System 7-4
6 When this SRP module is available, synchronize the SRP modules.
host1#synchronize
7
When the SRP modules are synchronized, reboot the SRP module
that you upgraded.
host1#reload slot 6
8 When this SRP module is available, synchronize the SRP modules.
host1#synchronize
9 When the SRP modules are synchronized, force the redundant SRP
module to take over from the primary SRP module.
host1#srp switch
10
Immediately remove the former primary SRP module.
11 Repeat steps 4 – 8 for the former primary SRP module.
Replacing an NVS Card
To replace an NVS card on an SRP module:
1
Obtain an antistatic container for the NVS card you will remove (see
Storing Modules and Components , earlier in this chapter).
2
With a small flathead screwdriver, remove the faceplate from the
NVS card slot on the SRP module (see
Figure 7-1 ).
3 Use the screwdriver to depress the button next to the NVS card (see
Figure 7-1 ).
This action releases the NVS card.