Jensen JiMS-520i User Manual
Page 11
10
the Volume Level and then the frequency reading for about 1 minute and then revert to current time.
Note:
1. When listening to an FM station, fully extend the antenna wire to insure maximum reception.
2. Automatic tuning operation may vary depending on the broadcast signal strength and also your
distance from the broadcast tower, so weaker stations may be skipped. Tune manually to find the
weaker stations. With stronger stations, the tuner may stop before it reaches the optimum setting for
that station. Adjust tuning manually for the best reception if necessary.
3. For FM reception, the Radio provides FM MONO/STEREO option. In FM STEREO mode, the unit
will automatically switch to stereo when a strong FM stereo broadcast is received and will indicate
“
” in the Display.
4. To receive a weaker (noisy) FM station, briefly press the SET/FM MODE Button to switch to MONO
mode. The reception may improve, but the sound heard is monaural (MONO).
5. The sound equalization can be adjusted for optimum sound reproduction depending on the style of
music you are playing. By pressing the EQ Button, you can switch between ROCK, POP, CLASSIC,
JAZZ, BASS or NORMAL equalization to suit your taste.
To Preset Channels
The JiMS-520i is equipped with 20 preset memories each for the AM and FM band. Once they are
preset, they can be instantly accessed by keying in the preset channel using the Numeric Buttons or
pressing the
▲
or
▼
Buttons on the Remote Control.
1. Press
the Button to turn on the unit.
2.
Press the FUNCTION Button to switch the unit to the Radio mode if required.
3.
Press the BAND Button to select AM or FM band as desired.
4.
Tune to a desired station.
5.
Press the MEMORY Button once. The Memory Indicator “MEMO” and the Channel Indicator “01”
will appear and flash in the Display.
6. While the Memory Indicator “MEMO” and the Channel Indicator “01” are flashing in the Display,
press the
▲
or
▼
buttons to select the desired preset channel.
7.
Press the MEMORY Button again to confirm when the desired preset channel appears in the
Display.
Note: The MEMORY and Preset Channel Indicators, “MEMO” and “01”, will disappear in the LCD
Display if no Button is pressed in 5 seconds and the receiver will exit the Preset Channel mode.
8.
Tune to another station and repeat steps 5 to 7 to store the new station in another preset channel.
To Receive Preset Stations
1. Press
the Button to turn on the unit.
2.
Press the FUNCTION Button to operate the unit in the radio mode.
3.
Press the BAND Button to select AM or FM band as desired.