Jensen JiMS-520i - Manual (Page 14)

13
DOCKING YOUR iPod
1. Press the Button to turn on the unit.
2. Press the FUNCTION Button to select the iPod mode.
3. According to TABLE 1, select a suitable adaptor for your iPod and insert it into the docking bay.
Your iPod can now be inserted onto the docking connector by aligning the connector on the
bottom of the iPod onto the connector in the docking bay.
Note : Please be careful when seating your iPod onto the dock to
avoid damaging the 30-pin connector in the iPod or the docking
system.
4. Verification will begin once the iPod is docked. The message
“ READING ” will be shown on the Display for a few seconds and then
“IPOD ” will be shown on the Display after the verification has completed.
5. The iPod will start playing and charging automatically.
6. Adjust the sound level by pressing the VOLUME +/- buttons on the JiMS-520i.
Note :
i. The volume level cannot be adjusted using the volume control on your iPod after being
docked.
ii. The Display will change from showing “IPOD” to the current time 1 minute after the
system has entered the iPod function mode.
iii. When the Volume +/- Buttons is pressed, the Display will first show the Volume Level,
then “IPOD“ for about 1 minute and then revert to current time again.
7. Repeatedly press the EQ Button on JiMS-520i to choose the desired equalizer effect.
Note : Set the EQ of your iPod to OFF so that it will not affect the correct operation of the EQ on
this unit.
8. To remove the iPod from JiMS-520i, press and hold the Button for few seconds to switch off
the iPod and then gently remove it from the docking connector.
9. To turn JiMS-520i off, press the STANDBY/ON Button again.