Jensen JiMS-520i User Manual

Page 15

Advertising
background image

14

DOCKING YOUR iPhone

1. Press

the Button to turn on the unit.

2. Press

the

FUNCTION Button to select the iPod mode.

3. According to TABLE 1, select the 30G adaptor and insert it into the docking area. Your iPhone can

now be inserted into the docking port by aligning the connector on the bottom of the iPhone onto

the connector in the docking.

Note: Please be careful when seating the iPhone onto the dock to avoid

damaging the 30-pin connector in the iPhone or the docking

system.

4. Verification will begin once the iPhone is docked. The message

READING

” will be shown in the Display for a few seconds and then

“IPOD

” will be shown in the Display after the verification has completed.

5. The iPhone will start playing and charging automatically.

6. Adjust the sound level by pressing the VOLUME +/- buttons on the JiMS-520i.

Note:

i.

The volume level cannot be adjusted using the volume control on your iPhone after

being docked.

ii.

The Display will change from showing “

IPOD

” to current time 1 minute after the system

has entered the iPod function mode.

iii.

When the Volume+ or Volume- Buttons is presses, the Display will first show the Volume

Level, then “IPOD“ for about 1 minute and then revert to current time again.

7. Press the EQ Button on the JiMS-520i to choose the desired equalizer effect.

Note: Set the EQ of your iPhone to OFF so that it will not affect the correct operation of the EQ

JiMS-520i.

8. Playback will be suspended if there is an incoming call and the iPhone will ring.

9. Touch the Answer icon on the iPhone once to answer the call.

10. Touch the Speaker icon on the iPhone once to answer the call in handsfree mode.

11. Press the End Call icon on the iPhone when you have finished your call. Music will resume.

Note: To enhance the sound quality in handsfree mode, use the 30G adaptor for docking the iPhone.

12. To remove your iPhone from JiMS-520i, press and hold the Button for few seconds to switch

off the iPhone and then gently remove it from the docking connector.

13. To turn JiMS-520i off, press the STANDBY/ON Button again.

Advertising