JVC RX-430VBK - Manual (Page 15)

English
Page 10
Basic Operations
The following operations are commonly used when you play any sound source.
Turning the Power On and Off (Standby)
On the front panel:
To turn on the power, press STANDBY/ON .
The STANDBY lamp goes off. The name of the current source (or station frequency) appears on the display.
To turn off the power (into standby mode), press STANDBY/ON again.
The STANDBY lamp lights up.
From the remote control:
To turn on the power, press AUDIO.
The STANDBY lamp goes off. The name of the current source (or station frequency) appears on the display.
To turn off the power (into standby mode), press AUDIO again.
The STANDBY lamp lights up.
Note:
Pressing STANDBY/ON
again turns off the power (into standby mode) and lights the STANDBY lamp.
A small amount of power is consumed in standby mode. To turn the power off completely, press POWER
to set it in the — OFF position on the front panel.
Selecting the Source to Play
On the front panel:
1. Press SOURCE so that Control % % % % % / fi fi fi fi fi buttons work for selecting the source.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until the source name you want appears on the display.
From the remote control:
Press one of the source button directly.
CD* Listen to the CD player.
TAPE* Listen to the cassette deck connected to the TAPE jacks.
FM/AM* Listen to an FM or AM (MW/LW) broadcast.
VCR View the video component connected to the VCR jacks.
VIDEO View the video component connected to the VIDEO jacks.
PHONO* Listen to a record.
Note:
* When you press one of the source buttons on the remote control marked above with an asterisk, the receiver
automatically turns on.
STANDBY
STANDBY/ON
STANDBY
STANDBY/ON
AUDIO
MUTE TUNED SLEEP SEA
AUTO STEREO PRO LOGIC 3CH LOGIC HALL LOUDNESS
L
VOLUME
R
CH- MHz
kHz
VOLUME
SOURCE
CD
TAPE
FM/AM
VCR
VIDEO
PHONO
Current source name appears Current volume level is shown here
RX-430VBK(EF)_0022-001A_En 97.4.24, 1:56 PM 10