JVC RX-430VBK - Manual (Page 9)

English
Page 4
AM
EXT
AM
LOOP
ANTENNA
GND
FM 75
COAXIAL
AM
EXT
AM
LOOP
ANTENNA
GND
FM 75
COAXIAL
AM
EXT
AM
LOOP
ANTENNA
GND
FM 75
COAXIAL
Connecting the FM and AM (MW/LW) Antennas
FM Antenna Connections
AM (MW/LW) Antenna Connections
AM
LOOP
ANTENNA
AM
EXT
GND
FM 75
COAXIAL
2 3 1
AM (MW/LW) Wire Antenna
AM (MW/LW) Loop Antenna
FM Antenna
Outdoor FM Antenna
B
A Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75-
ohm COAXIAL terminal as temporary measure.
B Using the Standard Type Connector (Not Supplied)
A standard type connector (IEC or DIN45325) should be
connected to the FM 75-ohm COAXIAL terminal.
Note: Make sure the antenna conductors do not touch any
other terminals, connecting cords or power cord. This
could cause poor reception.
Extend the supplied FM antenna horizontally.
If reception is poor, connect an outdoor FM
antenna.
Before attaching a 75-ohm coaxial cable (the
kind with a round wire going to the outdoor FM
antenna), disconnect the supplied FM antenna.
Snap the tabs on the loop into the slots of the
base to assemble the AM (MW/LW) loop.
Turn the loop until you have the best reception.
If reception is poor, connect an outdoor single vinyl-
covered wire to the AM EXT terminal. (Keep the AM
(MW/LW) loop antenna connected.)
Note :
Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This
could cause poor reception.
A
RX-430VBK(EF)_0022-001A_En 97.4.24, 1:55 PM 4