JVC RX-430VBK - Manual (Page 22)

English
Page 17
To cancel a stored preset station
Storing a new station on a used number erases the previously stored one.
CAUTION:
The preset channels may be erased in the following cases:
• When you press
POWER to set it in the — OFF position.
• When you unplug the power cord.
• When a power failure occurs.
Tuning in a Preset Station
On the front panel:
1. Press TUNER/BAND so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # # buttons work for tuner settings.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until “–PRESET+” appears on the display.
3. Press Control @ @ @ @ @ / # # # # # to select a preset channel.
Each time you press the button, the preset channels change.
• Pressing Control @ changes preset channel in decreasing order.
• Pressing Control # changes preset channels in increasing order.
From the remote control:
1. Press FM/AM.
The last received station of the last selected band is tuned in.
Each time you press the button, the band alternates between FM and AM (MW/LW).
2. Press 10 keys to select a preset channel number.
For channel number 5, press 5. For channel number 15, press +10 then 5.
For channel number 20, press +10 then 10. For channel number 30, press +10, +10 then 10.
Selecting the FM Reception Mode
You can change the FM reception mode while receiving an FM broadcast.
On the front panel only:
1. Press TUNER/BAND so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # # buttons work for tuner settings.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until “FM MODE” appears on the display.
3. Press Control @ @ @ @ @ / # # # # # to select either “FM AUTO” or “FM MONO.”
• Normally select “FM AUTO.”
• When an FM stereo broadcast is hard to receive or noisy, select “FM MONO.”
FM AUTO When a program is broadcast in stereo, you will hear stereo sound; when in monaural,
you will hear monaural sounds. This mode is also useful to suppress static noise between
stations.
The MUTE AUTO indicator lights up on the display.
FM MONO Reception will be improved although you will lose the stereo effect.
In this mode, you will hear noise while tuning into the stations.
The MUTE AUTO indicator goes off on the display.
Note:
You can store the FM reception mode for each preset station.
TUNER/BAND
4 5 6
1 2 3
TEST DELAY
PRESET SEA MODE
SURR MODE
7/P 8 9
10 +10
– +
CENTER
– + REAR
FM/AM
TUNER/BAND
RX-430VBK(EF)_0022-001A_En 97.4.24, 1:56 PM 17