JVC 0905TNH-FN-FN - Manual (Page 12)

12
Bef
o
re Y
o
u S
tart
EN
Installing Batteries in the
Remote Control
Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
Caution
• Incorrect use of batteries can result in hazards such
as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus and minus ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used
for a month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions
for environmental protection that apply in your
country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
About the Remote Control
• Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
• Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
• Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
• Replace the batteries when the operating range of
the remote control reduces.
VCR / DVD Recorder Switching
Because this product is a combination of a VCR and a
DVD recorder, you must select first which component
you wish to operate with [VCR/DVD] on the front
panel.
Press [VCR] on the remote control.
(Verify that the VCR light is lit.)
Press [DVD] on the remote control.
(Verify that the DVD light is lit.)
Note
• Pressing only [VCR/DVD] on the front panel DOES
NOT switch the mode of the remote control. You
MUST select the correct mode on the remote
control.
• Press [VCR/DVD] to select the DVD mode or the
VCR mode.
• You cannot switch to the mode (DVD or VCR) that is
in the timer-standby mode.
• If the media is available, you can start recording by
pressing [DVD REC I] or [VCR REC I] on the
remote control even if another equipment (DVD or
VCR) is selected. In this case, the mode of the
remote control will be automatically switched to the
appropriate component.
2 1 3
60˚
EJE CT OPE N/ CLO SE SET UP STAN DB Y/ON REP EAT ZO OM PR
RE TUR N
ME NU /LIS T
TO P M EN U
CL EA R AUDIO
PLA Y W
SLO OP
TIM ER SH OW VIE W PR OG
ON S CRE EN A B C .@ /:
D EF JK L G HI
M N O TU V PQ R S W X Y Z
1 4 7 2 5 8 0
3 6 9
EN TER
VC R
DVD
STA ND BY/O N
VCR
DU BBIN G PR
VCR /DV D
S-VIDEO VIDEO (MO NO) L -AU DIO -R
DVD
VCR
DVD
Within about
5 m
Remote
control
Code (DVD): JVC C
Code (VHS): JVC A
VCR mode
DVD mode
STANDBY/ON
VCR
DUBBING
PR VCR/DVD S-VIDEO VIDEO (MONO) L-AUDIO-R DVD
VCR DVD
VCR/DVD
VCR DVD
DVD light
VCR light
1_16_BeforeSrart_EN.fm Page 12 Monday, September 5, 2005 1:58 PM