JVC SP-UXNB7DAB - Manual (Page 19)

16
Learning More about This System
Basic and Common Operations (see page 5)
• Sound adjustments also aff ect the sound through the
headphones.
• Sound adjustments do not aff ect recording to the
external device.
• You can set the clock and daily timer while the Save
mode is turned on. While setting the clock or daily timer,
the display is turning on.
Playing Back Discs (see pages 7)
• This System cannot play “packet write” discs.
• For MP3 playback...
– MP3 discs are required a longer readout time than
regular CDs. (It depends on the complexity of the
group/fi le confi guration.)
– Some MP3 fi les cannot be played back and will be
skipped. This result from their recording processes and
conditions.
– When making MP3 discs, use ISO 9660 Level 1 or Level
2 for the disc format.
– This System can play back MP3 fi les with the extension
code <.mp3> (regardless of the letter case—upper/
lower).
– It is recommended that you make each MP3 fi le at a
sampling rate of 44.1 kHz and at bit rate of 128 kbps.
This System cannot play back fi les made at bit rate of
less than 64 kbps.
– Playback order of MP3 tracks may be diff erent from
the one you have intended while recording. If a folder
does not include MP3 tracks, they are ignored.
• This System can recognize up to 511 tracks in a disc.
Also, the System can recognize up to 150 tracks per
group and up to 99 groups in a disc. (for MP3)
– If there are any unplayable fi les in a folder, those fi les
are also counted in the total fi le number.
– Playable fi les which do not belong to any groups are
handled as Group 1.
MP3 groups/tracks confi guration
This System plays back MP3 tracks as follows.
Hierarchy
Level 1 Level 2 Level 3 Level 4 Level 5
Group with its play order
MP3 track with its play order
Listening to the Radio (see page 9)
• The time shown on the display by changing the DAB
information is based on the built-in clock of the system,
not on the information sent through DAB.
• The Enhanced Other Networks function is available only
when tuning in to FM.
Connecting a Portable Audio Device (see page 13)
Playing back a portable audio device:
• If a component connected to the LINE IN jack is not loud
enough, QP Link may not work properly.
In such cases, adjust the volume level of the component
louder so that the System can detect the sound signal
properly.
• Changing from “LINE” to another source while QP Link
works will deactivate QP Link temporarily.
In this case, the following reactivates QP Link:
– Pressing QP LINK on the remote control
– When no sound signal comes from the LINE IN jack for
about 30 seconds after the System is turned off
• If you press button to turn the System off or if preset
Timer turns the System off while QP Link works, the
System deactivates QP Link temporarily.
In such cases, the following reactivates QP Link:
– When no sound signal comes from the LINE IN jack for
about 30 seconds after the System is turned off
– When you turn on the power again
Setting the Clock and Daily Timer (see page 15)
• “0:00” will fl ash on the display until you set the clock.
• The clock may gain or lose 1 to 2 minutes per month. If
this happens, readjust the clock.
• When you unplug the AC power cord or if a power
failure occurs, the clock and the timer will be canceled.
You need to set the clock fi rst, then the timer again.
• When the on-time of the daily timer comes, the System
sets the volume level gradually to the preset level after
about 10 seconds.
Timer Priority:
• If you set the Sleep Timer after Daily Timer starts playing
the selected source, Daily Timer is canceled.
EN_01_20_UX-NB7DAB[B]ff.indd 16 EN_01_20_UX-NB7DAB[B]ff.indd 16 06.7.6 11:27:21 AM 06.7.6 11:27:21 AM