Troubleshooting, General, Radio operations – JVC SP-UXNB7DAB User Manual

Page 20: Disc operations, Timer operations

Advertising
background image

17

Troubleshooting

General

Power does not come on.

\ Power plug is not inserted securely. Plug in securely.

Adjustments or settings are suddenly canceled
before you fi nish.

\ There is a time limit. Repeat the procedure again.

Operations are disabled.

\ The built-in microprocessor may malfunction due to

external electrical interference. Unplug the AC power
cord and then plug it back in.

Unable to operate the System from the remote
control.

\ The path between the remote control and the

remote sensor on the System is blocked.

\ The batteries are exhausted.

No sound is heard.

\ Speaker connections are incorrect or loose.

\ Headphones are connected.

Radio Operations

Hard to listen to broadcasts because of noise.

\ Antennas connections are incorrect or loose.

\ The AM loop antenna is too close to the System.

\ The FM antenna is not properly extended and

positioned.

Cannot receive an ensemble.

\ Your area is not covered by the ensemble.

\ The DAB antenna is not properly extended or

positioned. Adjust the antenna and try the ensemble
scanning again.

\ Connect an active antenna (not supplied).

Disc Operations

The disc does not play.

\ The disc is placed upside down. Place the disc with

the label side up.

\ MP3 disc is recorded with the “packet writing (UDF

fi le).” It cannot be played. Check the fi les you want to
play back.

ID3 Tag on an MP3 disc cannot be shown.

\ There are two types of ID3 Tag—Version 1 and Version

2. This System can only show ID3 Tag Version 1.

MP3 groups and tracks are not played back as you
expect.

\ The playing order is determined when the disc was

recorded. It depends on the writing application.

The disc sound is discontinuous.

\ The disc is scratched or dirty.

The disc tray does not open or close.

\ The AC power cord is not plugged in.

Timer Operations

Daily Timer does not work.

\ The System has been turned on when the on-time

comes. Timer starts working only when the System is
turned off .

If you are having a problem with your System, check this list for a possible solution before calling for service.

EN_01_20_UX-NB7DAB[B]ff.indd 17

EN_01_20_UX-NB7DAB[B]ff.indd 17

06.7.6 11:27:23 AM

06.7.6 11:27:23 AM

Advertising