John Lewis JLBICO2 - Manual (Page 28)

Installation
Before installation
• Check that the input voltage indicated on
the rating plate is the same as the voltage of
the power outlet you are going to use.
• Open the oven door and take out all the
accessories and remove the packing
material.
• Do not remove the mica cover on the
ceiling of the interior! This cover stops fat
and pieces of food damaging the microwave
generator.
Warning! Warning! The front
surface of the oven may be wrapped
with a protective film. Before using the
oven for the first time, carefully
remove this film, starting on the inside.
• Make sure that the oven is not damaged in
any way. Check that the oven door closes
correctly and that the interior of the door
and the front of the oven opening are not
damaged. If you find any damage contact
the Technical Assistance Service.
• DO NOT USE THE OVEN if the power
cable or the plug are damaged, if the oven
does not function correctly or if it has been
damaged or dropped. Contact the
Technical Assistance Service.
• Put the oven on a flat and stable surface.
The oven must not be installed close to any
sources of heat, radios or televisions.
• During installation, make sure that the
power cable does not come into contact
with any moisture or objects with sharp
edges behind the oven. High temperatures
can damage the cable.
Warning! after the oven is installed
you must make sure you can access the
plug.
After installation
• The oven is equipped with a power cable
and a plug for single phase current.
• If the oven is to be installed on a permanent
basis it should be installed by a qualified
technician. In such a case, the oven should
be connected to a circuit with an all-pole
circuit breaker with a minimum separation
of 3 mm between contacts.
Warning! THE OVEN MUST BE
EARTHED.
• The manufacturer and retailers do not
accept responsibility for any damage that
may be caused to people, animals or
property if these installation instructions
are not observed.
• The oven only functions when the door is
closed correctly.
• After the first use, clean the inside of the
oven and the accessories, following the
cleaning instructions given in the section
'Maintenance and cleaning'.
Fit the Turntable support (1) in the centre of
the oven cavity and put the Turntable ring (2)
and the Turntable plate (3) on top, making
sure they slot in. Whenever you use the
microwave, the turntable plate and the
respective accessories must be inside and
correctly fitted. The turntable plate can rotate
in both directions.
28