JVC CA-MXS6MD - Manual (Page 18)

– 15 –
English
Selecting the Sound Modes
You can select one of the 6 preset sound modes (3 surround
modes and 3 SEA – Sound Effect Amplifier – modes) and 1
manual mode. The sound modes can be applied only to
playback sounds, and cannot be used for recording.
To select the sound modes, press SOUND on the remote
control until the sound mode you want appears on the
display. The SOUND indicator also lights on the display.
• Each time you press the button, the sound modes change
as follows:
Surround modes *:
D. (Dance) CLUB: Increases resonance and bass.
HALL:
Adds depth and brilliance to the
sound.
STADIUM: Adds clarity and spreads the sound,
like in an outdoor stadium.
SEA modes:
ROCK: Boosts low and high frequency.
Good for acoustic music.
POP: Good for vocal music.
CLASSIC: Good for classical music.
Manual mode:
MANUAL: Your individual mode stored in
memory. See “Creating Your Own
Sound Mode — MANUAL Mode”
on page 16.
FLAT: Cancels the sound mode.
* Surround elements are added to the sound modes to create a
being-there feeling in your room.
D.CLUB
FLAT
(Canceled)
HALL STADIUM ROCK
POP MANUAL CLASSIC
To store the display setting in memory
You can store the following display settings in
memory. So, even though the AC power is unplugged
or a power failure occurs, the settings are kept in
memory.
• Display demonstration off setting (see page 9)
• Animation character or level meter (see pages 14
and 62)
• Display color (see page 62)
On the unit ONLY:
1
Unplug the AC power cord.
2
Plug the AC power cord again while holding
7
and ENTER/DEMO at the same time.
3
Set the above settings as you like.
• Turn off the display demonstration. (See
page 9.)
If you turn it off and store its setting in backup
memory, display demonstration will not start
even after the AC power cord is reconnected or
when a power failure is recovered.
• Select the animation character or the level
meter. (See page 14 or 62.)
• Select the display color. (See page 62.)
To erase the memory
Repeat steps 1 and 2 of the above procedure.
Memory is cleared.
• When the AC power plug is reconnected or a power
failure is recovered, display demonstration
automatically starts.
EN10-16.CA-MXS6MD[US/UB]/f 00.10.10, 9:42 AM 15