JVC CA-MXS6MD - Manual (Page 44)

– 41 –
English
5
Press SET when you find the point where you want
to divide the track.
The MD recorder repeats the selected point
— a 3-second period following the dividing point.
• If the dividing point is satisfactory, go to step 7.
• If the dividing point is not satisfactory, go to the next
step.
6
Push and hold the joy control rightward ( ) or
leftward ( ) to precisely adjust the dividing point.
• You can shift the dividing point up to ±128. This
range (±128) corresponds to approximately ±8
seconds* from the original point (Position 0).
* When “SP” is selected for the recording length
mode. For “LP2,” it is approximately ±16 seconds,
and for “LP4” approximately ±32 seconds.
When you stop holding the joy control, the unit
repeats the newly selected dividing point.
• When you find the right position, go to the next step.
• If you want to cancel the dividing point, press
CANCEL, then select the correct dividing point.
7
Press SET.
8
Press ENTER/DEMO to finish the editing
procedure.
“EDITING” appears for a while, then “WRITING”
flashes while the editing you have made is being
recorded on the MD.
To join the divided tracks again, see the JOIN function.
DIVIDE Function
This function allows you to divide one track into two
separate tracks. It is useful, for example, when you want to
add track marks at a certain point within a track or if you
want to separate a recording.
• To stop any time during editing process, press TITLE/
EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
• It takes about 5 seconds for the unit to read the TOC
(Table Of Contents) of the inserted MD. While the
unit is reading it, you cannot go to the next step.
2
Press TITLE/EDIT.
The source is changed to “MD.”
• If “DIVIDE” is not shown, you cannot divide the
track.
3
Push the joy control downward ( ) to select
“DIVIDE” (highlighted), then press SET.
The first track (or the current track) starts playing.
4
Push the joy control rightward ( ) or leftward ( )
to select the track you want to divide.
The selected track starts playing.
• If you do not push the joy control rightward (
¢ )
or leftward (
4 ), the same track plays repeatedly.
• You can push and hold the joy control upward ( ¡
) or downward (
1 ) to find the dividing point.
Ex. When you want to divide track 5
If the track has a title, it is shown here.
Ex. When adjusting the point by +20
EN39-44.CA-MXS6MD[US/UB]/f 00.10.10, 9:49 AM 41