JVC UX-J99DVD - Manual (Page 72)

69
English
6
Press ENTER to finish the current title
entry.
“EDITING” appears on the display for a while, then the next
title entry screen appears.
• For the disc title:
The track title entry screen for the track 1 appears.
• For the track title:
The next track title entry screen appears (or the unit exits from
the title entry screen if the current track is the last one on the
disc).
• For the group title:
The next group title entry screen appears (or the same screen
still remains if the current group is the last one on the disc).
If you want to continue assigning a title, repeat steps 3 to 6 .
7
Press CANCEL to exit from the title
entry mode.
• While recording, do not go to the next step until the recording
ends.
8
Press
0 (MD eject) on the unit to eject
the MD.
“WRITING” and the REC (MD recording)
indicator flash while the editing you have made is
being recorded on the MD.
5
Enter characters.
(1) Press DISP/CHARA to select the character
set you want.
• Each time you press the button, the character
set changes as follows:
(2) Press the character entry button
for a character you want to enter.
Ex.:
• To enter an “A” or “a,” press ABC
once.
To enter a “B” or “b,” press ABC
twice.
To enter a “C” or “c,” press ABC
three times.
• To enter a symbol, press MARK repeatedly until the mark
you want appears. For available symbols, see below.
• To enter a numeral, press 0 – 9.
• To enter a space while entering a title, press UP
¢
twice.
• To move the character entry position while entering a title,
press UP ¢ or DOWN 4*.
• If you have entered an incorrect character, press UP ¢
or DOWN 4 to select the character you want to correct,
then press CANCEL to delete it.
* If you press DOWN 4 repeatedly during recording, the entered
characters may be displayed incorrectly. In this case, press TITLE
EDIT or GROUP TITLE EDIT, then repeat from step 3 again.
(3) Repeat steps 5 – (1) and 5 – (2) to enter other characters.
• If the character you want to enter next is assigned to the
same button you have just pressed in step 5 – (2), press
UP ¢ once to move the character entry position to the
right.
• The display can only show 6 characters at a time. If you
enter the 7th character, the first character disappears, and
so on.
Available symbols are as follows:
Capital letters
& Symbols Small letters
& Symbols
Numerals
MD
0
‹
/
8
Editing an MD
(Continued)
(Blank)
EN63-70_UX-J99DVD[UB]5.p65 03.12.12, 11:06 PM 69