Juniper Networks EX4200 User Manual
Page 228
JUNOS Software System Basics and Services Command Reference at
.
3.
Disconnect power from the switch by performing one of the following:
■
If the power source outlet has a power switch, set it to the OFF (0) position.
■
If the power source outlet does not have a power switch, gently pull out the
male end of the power cord connected to the power source outlet.
4.
Remove the cables that connect the switch to all external devices.
5.
Remove all field-replaceable units (FRUs) from the switch.
6.
If the switch is installed on a wall, rack, or cabinet, have one person support the
weight of the switch while another person unscrews and removes the mounting
screws. Use the Phillips (+) screwdriver, number 2 to remove the screws.
7.
Remove the switch from the wall, rack, cabinet, or desk (see “Chassis Lifting
Guidelines for EX3200 and EX4200 Switches” on page 220) and place the switch
in an antistatic bag.
8.
Place the switch in the shipping carton.
9.
Place the packing foam on top of and around the switch.
10.
If you are returning accessories or FRUs with the switch, pack them as instructed
in “Packing EX3200 or EX4200 Switch Components for Shipping” on page 202.
11.
Replace the accessory box on top of the packing foam.
12.
Close the top of the cardboard shipping box and seal it with packing tape.
13.
Write the RMA number on the exterior of the box to ensure proper tracking.
Packing EX3200 or EX4200 Switch Components for Shipping
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not fit together on one level in the shipping box.
To pack and ship EX Series switch components:
■
Place individual boards in antistatic bags.
■
Ensure that the components are adequately protected with packing materials
and packed so that the pieces are prevented from moving around inside the
carton.
■
Close the top of the cardboard shipping box and seal it with packing tape.
■
Write the RMA number on the exterior of the box to ensure proper tracking.
Related Topics
■
Returning an EX3200 or EX4200 Switch or Component for Repair or Replacement
on page 197
■
Removing a Fan Tray from an EX3200 or EX4200 Switch on page 174
■
Removing a Power Supply from an EX3200 or EX4200 Switch on page 172
202
■
Packing EX3200 or EX4200 Switch Components for Shipping
Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches