Juniper Networks EX4200 - Manual (Page 247)

Ramp Warning for EX Series Switches
WARNING: When installing the switch, do not use a ramp inclined at more than 10
degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10 graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10 degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related Topics ■ General Safety Guidelines and Warnings for EX Series Switches on page 207
■ Laser and LED Safety Guidelines and Warnings for EX Series Switches on page 213
■ Installation Instructions Warning for EX Series Switches on page 219
■ Grounded Equipment Warning for EX Series Switches on page 226
Rack-Mounting and Cabinet-Mounting Warnings for EX Series Switches
Ensure that the rack or cabinet in which the EX Series switch is installed is evenly
and securely supported. Uneven mechanical loading could lead to a hazardous
condition.
WARNING: To prevent bodily injury when mounting or servicing the switch in a rack,
take the following precautions to ensure that the system remains stable. The following
directives help maintain your safety:
■ The switch must be installed in a rack that is secured to the building structure.
■ The switch should be mounted at the bottom of the rack if it is the only unit in
the rack.
Ramp Warning for EX Series Switches ■ 221
Chapter 19: Installation and Maintenance Safety Information