Juniper Networks EX4200 - Manual (Page 264)

Related Topics ■ General Safety Guidelines and Warnings for EX Series Switches on page 207
■ See Rear Panel of an EX2200 Switch for the ESD point location.
■ See Rear Panel of an EX3200 Switch on page 9 for the ESD point location.
■ See Rear Panel of an EX4200 Switch on page 11 for the ESD point location.
■ See Chassis Physical Specifications of an EX8208 Switch for the ESD point
location.
■ See Chassis Physical Specifications of an EX8216 Switch for the ESD point
location.
AC Power Electrical Safety Guidelines for EX Series Switches
CAUTION: For switches with AC power supplies, an external surge protective device
(SPD) must be used at the AC power source.
The following electrical safety guidelines apply to AC-powered switches:
■ AC-powered switches are shipped with a three-wire electrical cord with a
grounding-type plug that fits only a grounding-type power outlet. Do not
circumvent this safety feature. Equipment grounding must comply with local
and national electrical codes.
■ You must provide an external certified circuit breaker rated minimum 20 A in
the building installation.
■ The power cord serves as the main disconnecting device for the switch. The
socket outlet must be near the switch and be easily accessible.
■ For EX Series switches that have more than one power supply connection, you
must ensure that all power connections are fully disconnected so that power to
the switch is completely removed to avoid electric shock. To disconnect power,
unplug all power cords (one for each power supply).
■ Note the following warnings printed on the label next to the power supplies:
“CAUTION: THIS UNIT HAS MORE THAN ONE POWER SUPPLY CORD.
DISCONNECT ALL POWER SUPPLY CORDS BEFORE SERVICING TO AVOID
ELECTRIC SHOCK.”
238 ■ AC Power Electrical Safety Guidelines for EX Series Switches
Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches