JVC UX-Z7MDR - Manual (Page 36)

– 31 –
2) Press the character entry button for a character
you want to enter.
Ex.:
• To enter an “A” or “a,” press ABC once.
To enter a “B” or “b,” press ABC twice.
To enter a “C” or “c,” press ABC three times.
• To enter a symbol, press MARK repeatedly until
the mark you want appears.
• To enter a numeral, press 0 – 9.
• To enter a space while entering a title, press
twice.
• To move the character entry position while
entering a title, press or .
• If you have entered an incorrect character, press
or to select the character you want to
correct, then press CANCEL to delete it.
3) Repeat steps 4 – 1) and 4 – 2) to enter other
characters.
• If the character you want to enter next is assigned
to the same button you have just pressed in step
4 – 2), press
once to move the character entry
position to the right.
5
Press ENTER.
“SEARCH • • •” scrolls and the TITLE SEARCH
indicator starts flashing on the display. The unit starts
searching for the track.
• When the track with the desired title is found, the unit
plays back the track. (After the track is played, the
unit starts searching for the next matching track.)
• If no track with the desired title is found, “SEARCH
END” appears in the main display and Normal play
mode resumes (the TITLE SEARCH indicator goes
off).
To skip the current playback and search for the next
track, press
¢.
To cancel title searching, press TITLE SEARCH.
When you press the button during playback or search,
Normal play resumes.
Available symbols are as follows:
Searching for Tracks to Play
—MD Title Search
You can search for the tracks by their titles and play them
back.
For details on assigning a title, see pages 59 and 60.
On the remote control ONLY:
1
Load an MD.
2
Press MD
3/8, then 7.
The source is changed to “MD.”
3
Press TITLE SEARCH.
The TITLE SEARCH indicator lights up on the display.
The play mode changes to Normal play.
“TITLE” and the character entry position appear in the
main display.
4
Enter the character(s) to search for the track title.
You can enter up to 5 characters. The unit will search
for the tracks which have the entered characters at the
head of their titles.
• You can also search for the tracks without a title. In
this case, go to step 5 without entering any character.
1) Press DISP/CHARA to select the character set
you want.
• Each time you press the button, the character set
changes as follows:
TITLE SEARCH indicator
Character entry position Character set
(Blank)
Capital letters &
Symbols
Small letters &
Symbols
Numerals
EN26-31UX-Z7MDR[B]f 02.6.28, 13:48 31