JVC UX-Z7MDR - Manual (Page 48)

– 43 –
To record a single track during play or pause
On the main unit ONLY:
While playing back or pausing a track you want to
record, press MD&TAPE REC.
The playback of the track is stopped, and the same track starts
playing from the beginning again. This time, the MD recorder
and cassette deck start recording the track.
• After the track is recorded, both playback and recording
stop automatically.
To change the information shown in the main display
On the remote control ONLY:
Press DISP/CHARA.
• Each time you press the button, the information in the
main display alternates between the recording indication
and the clock indication.
When recording from a CD-R/RW
You cannot make a digital recording from a digital-copied
CD-R/RW on an MD. “SCMS CANNOT COPY” appears in the
main display and an analog recording starts (see page 70).
When recording on an MD and a tape at the same
time
A 4-second blank before the first track is not made on the tape.
Recording CD onto an MD and a Tape
—CD Synchronized Recording
With this recording method, you can start and stop CD
play, MD and tape recordings at the same time.
1
Prepare a disc .
After placing a disc, press CD
3/8, then 7 before
going to the next step.
• You can make a program (see page 24) or select
Random play mode (see page 25) if you want.
2
Insert a recordable MD into the MD loading slot
and put a recordable cassette into the cassette
holder.
For the MD:
Set the MD recording length mode, “LP:”-prefix
addition mode, and Group recording mode (see
“Setting MD Recording Modes” on page 39).
For the tape:
Press REV.MODE to select the reverse mode (
).
3
Press x1,2,4 on the remote control to select x1
(normal speed recording).
• You cannot use x2 or x4 speed recording. (If you try
to do so, “CANNOT REC x1 REC ONLY” will
appear in step 4 below.)
4
Press MD&TAPE REC.
CD play and the recording start.
• When you select a track by pressing
¢ or 4
before pressing MD&TAPE REC, recording starts
from the selected track (except when Program play
mode is selected).
The MD REC and REC indicators start flashing on the
display.
After the recording, the CD player, MD recorder and
the cassette deck stop automatically.
To stop recording, press 7.
“WRITING” flashes in the main display for a while.
MD remaining
recording time The track No. on the disc
currently being recorded
MD and tape
recording indicators Remaining
playing time
EN36-43UX-Z7MDR[B]f 02.6.28, 13:49 43