JVC UX-Z7MDR - Manual (Page 67)

– 62 –
3
Select the source to record.
1) Press ¢ or 4 repeatedly to select the source.
• Each time you press the button, the source
changes as follows:
• When you select “FM” or “AM,” press SET, then
select a preset number by pressing
¢ or 4.
• When you select “AUX,” set the timer function
of the external component as well.
2) Press SET.
The device to be recorded onto flashes in the main
display.
4
Select the device to be recorded onto.
1) Press ¢ or 4 repeatedly to select the device.
2) Press SET.
• When you select “MD REC,” select the recording
length mode (see page 39) by pressing
¢ or 4,
then press SET again.
• When you select “TAPE REC,” select the reverse
mode (see page 42) by pressing REV.MODE.
The hour digit of the timer-on time starts flashing.
5
Set the timer-on time.
1) Press ¢ or 4 repeatedly to adjust the hour.
You can adjust the hour using the number buttons.
2) Press SET.
The minute digit starts flashing.
3) Press
¢ or 4 repeatedly to adjust the minute.
You can adjust the minute using the number buttons.
4) Press SET.
The hour digit of the timer-off time starts flashing.
There are three timers available—Recording Timer, Daily
Timer and Sleep Timer.
• Before using these timers, make sure the built-in
clock is set correctly (see page 12).
• When using the tuner as the source, preset stations in
advance (see page 17).
Using Recording Timer
With Recording Timer, you can make an unattended
recording.
• You can set Recording Timer whether the unit is turned
on or in standby mode.
• To correct a mis-entry any time during the setting
process, press CANCEL.
• To exit from the timer setting mode during the setting
process, press CLOCK/TIMER repeatedly until the
source indication appears.
How Recording Timer actually works
The unit automatically turns on, muting the volume, and
starts recording on the MD or on the tape when the timer-
on time comes. Then, when the timer-off time comes, the
unit automatically turns off (stands by).
Recording Timer works only once, but the timer settings
remain stored in memory until you reset them or unplug the
AC power cord.
1
Press CLOCK/TIMER repeatedly until “REC
TIMER” appears in the main display.
The timer (
) indicator lights up and the REC
indicator starts flashing on the display.
• Each time you press the button, the timer mode
change as follows:
2
Press SET.
The source name flashes in the main display.
Continued
MD REC TAPE REC
Ex.: When you set timer-on time to 11:30.
Source indication
REC TIMER DAILY TIMER
Clock time
(canceled)
AM FM
AUX
To be continued on the next page
]
EN61-65UX-Z7MDR[B]f 02.6.28, 13:52 62