JVC CA-MXJ787V - Manual (Page 12)

7
English
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries
use 10 kHz spacing.
On the unit On the unit ONLY ::
You can only change the AM tuner interval spacing while tuning
into an AM station.
Press FM/AM u while holding down 7 z.
• Each time you press the button, the AM tuner interval spacing
alternates between 9 kHz and 10 kHz.
NOTE: Preset memory lost when the interval spacing is changed.
Turning On the Power and Selecting the Sources
When you press the play button for a particular source (FM/AM,
CD
6, AUX, and TAPE 2 3 ), the unit turns on, and the Powered
Rolling Panel opens automatically (and the unit starts playing the
source if it is ready — COMPU PLAY CONTROL).
To listen to the FM/AM broadcasts, press FM/AM u, ¡. (See
page 17.)
To play back CDs, press CD 6 y, _. (See pages 10 – 12.)
To play back tapes, press TAPE 2 3 7, =. (See page 18.)
To select the external equipment as the source, press AUX
p, !.
To turn on the unit without playing, press 2 , @
so that the STANDBY lamp goes off.
The Powered Rolling Panel opens automatically.
To turn off the unit (on standby), press 2 , @
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.
A little power is always consumed even while the unit is
on standby.
To switch off the power supply completely, unplug the AC power
cord from the AC outlet.
When you unplug the AC power cord or if a
power failure occurs
The clock is reset to “0:00” right away, while the tuner preset stations
(see page 17) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built in this
unit.
1
Press PANEL OPEN/CLOSE 5.
The unit is turned on and the Powered Rolling Panel
opens automatically.
2
Press TIMER/CLOCK h.
The hour digits start flashing on the display.
3
Press 4 ; or ¢ ; to adjust the
hour, then press SET k.
• If you want to correct the hour after pressing SET
k, press CANCEL /. The hour digits start
flashing again.
4
Press 4 ; or ¢ ; to adjust the
minute, then press SET k.
To adjust the clock again
If you have adjusted the clock before, you need to press TIMER/
CLOCK h repeatedly until the clock setting mode is selected.
• Each time you press the button, the timer/clock setting modes
change as follows:
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set
the clock again.
Continued
DAILY
Cancelled
ON TIME
ON TIME Clock
setting
(The hour digits start flashing.)
REC
TIMER
/CLOCK
PRESET
PREV NEXT
SET
SEA CONTROL
PRESET
PREV NEXT
SET
SEA CONTROL
FM AM /
FM AM / AUX TAPE C D
STANDBY
STANDBY
PANEL
OPEN / CLOSE
Common Operations Common Operations
EN6-17;MX-J777V/PM6 7/8/99, 9:16 AM 7