JVC CA-MXJ787V - Manual (Page 15)

10
English
Continued
Placing CDs
1
Press 0 e for the disc tray (CD 1 to 3)
you want to load a CD onto.
The unit automatically turns on and the disc tray
comes out. The Powered Rolling Panel also opens
automatically.
2
Place a disc correctly on the circle of the disc tray,
with its label side up.
• When using a CD single (8 cm), place it on the inner circle of
the disc tray.
3
Press the same 0 e you have pressed
in step 1.
The disc tray closes, and the corresponding disc
number indicator (CD 1 to CD 3) lights up on the
display.
4
Repeat steps 1 to 3 to place other CDs.
When placing more than one CD continuously
When you press 0 e for the next tray you want to place another
CD onto, the first disc tray automatically closes and then the next
tray comes out.
NOTE: When placing another CD, wait until current CD
playing or stop playing.
About the disc indicators
Each disc indicator corresponds to the disc tray of the same number.
Disc number
Disc indicator
2 3 1
Disc marker
• The disc marker lights up for the disc number you have selected.
• The disc indicator flashes while the corresponding CD is being
played.
• The disc indicator goes off when the unit has detected that there
is no CD on the corresponding disc tray.
Playing Back the Entire Discs — Continuous Play
You can play CDs continuously.
1
Place CDs.
2
Press one of the disc number buttons
(CD 1, CD 2, and CD 3) r, 1 for the
disc you want to play.
CD play starts from the first track of the selected
disc.
Playing Back Audio CDs Playing Back Audio CDs
CD 1
CD 2
CD 3
2 3 1
1
5
9
13
2
6
10
14
3
7
11
4
8
12
Tracks of the currently playing disc
Track number Elapsed playing time
• Pressing CD 6 y, _ instead of the disc number buttons
starts playing back if a CD is in the trays.
To stop during play, press 7 z, +.
To remove the disc, press 0 e for the corresponding disc tray.
CD playback sequence
When 3 CDs are loaded on the disc trays, they are played in one of
the following sequences.
• When CD 1 is pressed : CD 1
] CD 2 ] CD 3 (then stops)
• When CD 2 is pressed : CD 2 ] CD 3 ] CD 1 (then stops)
• When CD 3 is pressed : CD 3 ] CD 1 ] CD 2 (then stops)
* When only 2 CDs are loaded, they are played in the same order,
but the disc tray without a CD is skipped.
Basic CD Operations
While playing a CD, you can do the following operations.
To exchange CDs during playback of another
Press 0 e corresponding to a CD, not playing or selected currently,
to eject and exchange the CD.
If you exchange CDs during play, the current play will not stop
until all CDs you have exchanged are played.
To stop play for a moment
Press CD 6 y, _.
While pausing, the elapsed playing time flashes on
the display.
To resume play, press CD 6 y, _ again. C D
INCORRECT CORRECT
EN6-17;MX-J777V/PM6 7/8/99, 9:16 AM 10