SmartBridges sB3412 - Manual (Page 11)

Page 11 of 78
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airClient™ Nexus PRO TOTAL User Guide
2. aCNPT Configuration
The airClient Nexus PRO TOTAL can work in one of three modes: Bridge, Router and NAT. The
procedures for configuring the various parameters in each mode are outlined in this chapter.
2.1. User Login and License Agreement
The aCNPT unit comes with a pre-configured default Ethernet (wired-side) IP address: 192.168.0.210 and
subnet mask: 255.255.255.0. This default device IP address should be used when accessing the device
configuration management interface for the first time using a web-browser (Enter http://192.168.0.210 for
the URL address). In addition, the Sun Java Plug-in should be installed. The PC must be on the same
subnet as the aCNPT.
Follow the steps below to login as an Administrator to the web-based configuration management interface
system:
1. Connect the aCNPT using the Power over Ethernet (PoE) to a PC or network via the ETH A or
ETH B port. (Please refer to the Quick Install Guide for more information on connections).
2. Open a web browser on the PC and enter the device IP address 192.168.0.210 in the web
browser address field and press the Enter key.
3. A user login box will appear. Enter the ’User name’ and ’Password’ and check the ’Remember my
password’ checkbox if you want the system to remember the password. The default user name is
Administrator and the password is smartBridges (case sensitive).
Figure 2-1 Administrator Login
4. Click the ’OK’ button. A license agreement page will appear as shown in Fig 2-2 below.
5. Click ‘Accept’. The aCNPT ’Nexus Summary Information’ page (Fig 2-3) will appear.